Instructions
For
Dixon Bayco
FT451 Ground Bolt Installation
For Sales and Service Contact
USA:
Dixon Bayco USA
Chestertown, Maryland
Phone: 410-778-2000
Fax: 410-778-4702
Toll Free: 800-355-1991
E-mail: [email protected]
Europe:
Dixon Group Europe Ltd
Preston, England
Phone: +44 (0)1772 323529
Fax: +44 (0)1772 314664
E-mail: [email protected]
Mexico:
Dixva, S. de R.L. de C.V.
Monterrey, N.L
Phone: 01-800-00-DIXON (34966)
Fax: 01-81-8354-8197
E-mail: [email protected]
Canada:
Dixon Group Canada Limited
Innisfil (Barrie), Ontario
Phone: 705-436-1125
Fax: 705-436-6251
Toll Free: 877-963-4966
E-mail: [email protected]
Asia Pacific:
Dixon (Asia Pacific) Pty Ltd Wingfield,
South Australia
Phone: +61 8 8202 6000
Fax: +61 8 8202 6099
E-mail: [email protected]
dixonvalve.com
FT451 Ground Bolt Installation
Installation
This procedure is for the installation of the FT451 Self Proving
Grounding Ball.
1. Find a clear location on the trailer main frame support that is within reach of the rack grounding cable. This area is normally near the overfill sockets. Drill a 17/32" hole in the middle area of the frame support. Remove all sharp edges and clean the surface area around the hole.
2. Drill a ¼" hole approximately 4.0" to the left or right of the 17/32" hole. Clean the area around the ¼ drilled hole.
3. Crimp the eyelet on the end of the green wire.
4. Mount the ground ball in the 17/32" hole with the round end facing the outside of the trailer. The round ball end is where the rack ground plug is to connect.
5. Fasten the green wire by bolting the eyelet to the frame through the
¼" hole, using the ¼" bolt, lock washer, and nut.
6. Apply a small amount of grease on both the ½" and ¼" nuts to block moisture from effecting continuity.
Do not use electric drills or tools that generate heat, sparks, or use electricity near a petroleum tanker unless the tank has been purged of flammable gases.
Dixon Bayco Warranty
For complete warranty information, please refer to the latest
Dixon catalog.
2 REV MARCH 2004 FT451 GROUND BOLT INSTAL
