40070PA AIR INTERLOCK ELECTRICAL SWITCH
Maintenance & Operating Instructions
For
Dixon Bayco
5000xS Series
AIR INTERLOCK ELECTRICAL SWITCH
For Sales and Service Contact
Europe:
Dixon Group Europe Ltd.
Preston, England
Phone: +44 (0) 1772 323529
Fax: +44 (0) 1772 314664
Email: [email protected]
Mexico:
Dixva, S. de R.L. de C.V.
Monterrey, N.L
Phone: 01-800-00-DIXON (34966)
Fax: 01-81-8354-8197
E-mail: [email protected]
Canada:
Dixon Group Canada Limited
Innisfil (Barrie), Ontario
Phone: 705-436-1125
Fax: 705-436-6251
Toll Free: 877-963-4966
E-mail: [email protected]
Asia Pacific:
Dixon (Asia Pacific) Pty Ltd Wingfield, South
Australia
Phone: +61 8 8202 6000
Fax: +61 8 8202 6099
E-mail: [email protected]
USA:
Dixon Bayco USA
Chestertown, Maryland
Phone: 410-778-2000
Fax: 410-778-4702
Toll Free: 800-355-1991
E-mail: [email protected]
dixonvalve.com
REV F 2017/05/23
877.582.3569
1
P40070PA AIR INTERLOCK ELECTRICAL SWITCH
REV F 2017/05/23
877.582.3569
2
P40070PA AIR INTERLOCK ELECTRICAL SWITCH
Tools required for installation and part replacement
3/4" open end wrench
INSTALLATION
CAUTION!
SAFETY GLASSES MUST BE WORN DURING
INSTALLATION AND SERVICE.
CAUTION!
END PLUG IS RESTRAINING A COMPRESSION
SPRING. ENSURE THAT YOU HAVE A FIRM GRIP ON
THE END PLUG BEFORE REMOVING
REV F 2017/05/23
877.582.3569
3
P40070PA AIR INTERLOCK ELECTRICAL SWITCH
ASSEMBLY
1. Using the 3/4" open-end wrench, remove the end plug from the existing Dixon Bayco
Air interlock valve. Hold the end plug firmly to prevent the spring from ejecting the plug
from your hand. You may discard the end plug.
2. Remove the main spring.
3. Install the magnet inside of the spring and put the spring and magnet back inside the
body such that the head of the magnet goes in first. See drawing.
4. Install the switch assembly into the Air Interlock Body (compressing the spring) and
tighten with the ¾” open end wrench.
5. Connect the wire cable to the switch assembly by aligning the notch in the wire plug
to the projection in the switch receptacle. Tighten the collar of the wire cable to secure
it to the switch assembly.
6. Attach strain relief to onboard monitor housing and run the wire cable through the
strain relief and into the onboard monitor housing.
7. Connect the brown and white wires of the cable to the AUX port of the on board
monitor.
8. Cut off the blue and black wires.
9. Attach the warning label to the switch as shown, such that the label is visible to
operators.
DIXON BAYCO WARRANTY
For Warranty Information, please refer to the inside back cover of the latest Dixon
Catalog.
REV F 2017/05/23
877.582.3569
4
">
