Belle Foret Mono Block Single-Handle Bar Faucet installation Guide
ಜಾಹಿರಾತು
ಜಾಹಿರಾತು
For Models:
B F505
Preparation/Assembly
1 Make sure there is a Ø35-Ø40 Hole on the basin before fix the mixer, Unscrew the fitting
ASSY from the bottom of the body, then get the body through the hole, don't forget to fix
the o-ring between the bottom of the body and the basin.
2 According the remove step to screw up the fixing set to the mixer below the basin.
3 Use hand to screw up the locknut, then use nstall tool for fixing strengthen.
4 Connect the inlet hose from the body,"Red" for connecting to the hot water,and
"Blue" for connecting to the cold water.
Steps1-4
Ø35 Ø40Max
Installation
5 Pull the handle right is open, the angle you pull are more, the flow rate is
becoming large, conversely the angle you pull are small, the flow rate is becoming little till close.
Parts Breakdown
Aerator
Hex wrench
Spout
Cartridge
Nut
Handle cap
Trim cup
Hose
Parts Diagram
ಡೌನ್ಲೋಡ್ ಮಾಡಿ
ಜಾಹಿರಾತು