Cub Cadet ST 100 22 in. 159cc Gas Walk Behind String Trimmer Mower Operator’s manual

Assembly & Set-Up
Contents of Carton
. String Trimmer (1) . Pack of Trimmer Line (1) . Oil (1)
. String Trimmer Operator's Manual (1} + Engine Operator's Manual (1)
Assembiy 3. Move the upper handle into one of three positions by
pivoting it forward or rearward, Secure the upper handle
NOTE: This string trimmer is shipped without gasoline or oil in to the lower handle using the wing knobs (a) and carriage
the engine. Fill up the gasoline and oil as instructed in the Engine bolts (b} removed in Step 1, See Figure 3-2.
Operators Manual BEFORE operating your machine. Note: Make sure to use the corresponding hole on the left
Upper Handle ‚ side as on the right side of the upper handle.
1. Remove the wing knob {a} and carriage bolt (b) from the
left lower handle and the right lower handle.
See Figure 3-1.
2. Pivotthe upper handle into the operating position.
See Figure 3-1,
Figure 3-2
Figure 3-1
Starter Rope Set-Up
1. Disconnect the spark plug boot from the spark plug {refer Gas and Gil Fill-Up
to the Engine Operator's Manual},
Refer to the Engine Operators Manual for additional engine
2, Pivot the control handíe against the upper handle and pul information.
the rope out of the engine.
1. Add oil provided before starting unit for the first time.
Loop the rope through the eye bolt. See Figure 3-3,
Tighten the eye boit to the handle using the lock nut. DO
NOT overtighten,
4 >
2, Service the engine with gasoline as Instructed in the
Engine Operator's Manual.
WARNING: Use extreme care when handling
à gasoline. Gasoline is extremely flammable and the
RB. vapors are explosive. Never fuel the machine
® indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and any other
sources of ignition.
Figure 3-3
10 SECTION 3 — AssemeLY 8 SET-Up