EcoPure EPU2C Basic Carbon Universal Fit Under Sink Replacement Water Filter (Fits EPU3 System) Use and care guide
Add to my manuals
1 Pages
The ECOPURE EPU2C is a versatile water filtration system that provides clean, fresh-tasting drinking water right from your tap. With its innovative technology, it reduces harmful contaminants such as lead, chlorine, and cysts, as well as improves the taste and odor of your water.
advertisement
◉
Touch to zoom
ITEM #1000 1000 803 388 CAN MODEL# MODEL#HCGUSS5 HCGUSS5 Use and Care Guide Basic Drinking Water Filtration System INSTALLATION LOCATIO LOCATION N □ □ To filter water to a faucet, install the filtration system on the COLD supply water pipe to that faucet. SINK A mounting bracket and screws are included to support the filter assembly. IN Allow a minimum of 2 in. under the filter for removing the sump in order to change the filter cartridge cartridge. OU OUT Cold Water 3/8 in. Male NPT Adaptor (2) Installation 1 □ □ □ □ □ □ □ 2 Installing the filtration system Obtain two 3/8 in. male NPT adaptors (not included) oof the appropriate size and type to adapt to the sink’s existing cold water supply pipe. Shut off the hot and cold water supply to the sink and open the faucet(s) to re relieve lieve pressure in the cold water pipe. Cut out a section of the COLD water supply pipe several inches long, as needed to install the filtration system system.. See the Installation Location drawing. Apply four wraps of sealant tape to the threads of the 3/8 in. male le NPT adaptors (not included) and carefully turn them into the filter’s inlet and outlet ports. With the IN side of the water filter toward the incoming water, make connections as the Installation Location figure shows shows. When tighteni tightening ng compression nuts, use se a second wrench to hold the 3/8 in in. male NPT adaptor while turning the nut. Fully open the cold water faucet downstream of the filtration system system. Slowly lowly turn the water supply back on and check for leaks. Turn off the cold water faucet when the water flow becomes smooth. Installing or replacing a filter cartridge CAUTION CAUTION: Never remove the sump with water pressure in the filter. O-Ring Seal Close the water supply shutoff valve to the filter. To relieve pressure in the filtration system system, open the cold water faucet downstream of the filter. □ Carefully tturn urn the sump to the left to remove from the hhead, ead, as the sump is full of water. Do not lose the O-ring seal. □ Be sure the inside of the sump is clean. Thoroug Thoroughly hly wash with warm, soapy water and rinse. □ Remove the wrapper from the new filter cartridge and iinsert nsert the filter cartridge into the sump. Some filter cartridge cartridges fit either way, while oothers thers fit only one way. Observe markings on the filter cartridge cartridge,, or on the wrapper. □ Lightly lubricate the O-ring ring seal, in the sump, with sil silicone icone grease grease.. Be sure it is fully seated in the groove. Hold the sump up to the filter head, aligning the center hole in the filter cartridge with the protrusion on the bottom of the head. NOTE: If the sump will not tight tighten en to the head, you may have the filter cartridge in upside down or not centered in the sump. Take the filter cartridge out and check for correct orientation. □ Being careful not to cross cross-thread, thread, turn the sump to the right onto the filter head and tighten se securely. curely. Do not overtighten. □ Partially open the faucet downstream of the filtration system system.. Then, slowly open the water supply shutoff valve and allow the filter housing to fill with water. □ Close the faucet. Then, check for leaks between the sump and the he head. ad. NOTE: If a leak is occurring, turn off the water supply and depressurize the filtration system system.. Then, remove the sump and check the O-ring ring for cuts, flat spots, etc., and sealing surfaces for foreign material. Clean the O-ring ring and lubricate with silicone grease. Carefully press into the groove in the sump. NOTE: Taste and Odor filter cartridges contain activated carbon which is a black powder. After the new filter cartridge is installed, open the faucet downstream of the filtration system and allow ow carbon particles to purge from the filter cartridge cartridge.. Close the faucet when you no longer see “fines” (discoloration) in the filtered water, or approximately 2 - 3 minutes. REPLACMENT FILTER NOTE: The rated flow of HDXVOF4 & HDXLTF4 are 0.5 & 0.6 gpm (at 50psi) respectively which may be less than the typical sink faucet flow rate. Using these filters on a system installed on a primary sink fa faucet ucet may adversely affect the faucet flow rate. Filter Cartridge □ Sump Turn to the left to remove ve Replacement Parts: □ □ HCGAOO5 – O--ring HCXAWO5 – Sump removal wrench (not included) Uses HDX™ Under Under--Sink Filters: □ HCXVOF5 - Premium Under Sink Filter □ HCXLTF5 - Advanced Under Sink Filter □ HCXCTF5 - Basic Under Sink Filter □ Other standard drop drop-in in under under-sink filters See Replacement Filter Note Safety Information □ □ □ □ □ □ □ Check with your local public works department for plumbing codes. You must follow their guidelines as you install the water filtration system. Do not use this system on water that is microbiologically unsafe or of unknown quality without adequate disinfection before oorr after the system. This system is onl onlyy for use on COLD water (100°F / 38°C max.). Do not install on a hot water supply. Do not install this system where it will be exposed to outdoor weather or direct sun. Do not install or store this system where it will be exposed to temperatures below free freezing. zing. Water freezing in the system will damage it. The maximum operating water pressure of this system is 100 PSI.. If your home water pressure exceeds 80 PSI,, install a pressure reducing valve before install installing the filter filter. This product was evaluated for certification without a faucet. Should this product be used with a non non-NSF NSF Standard 42 faucet the system is no longer considered ce certified rtified as this faucet may not have been evaluate for lead content, material safety, and/or structural integrity. Faucet air gap requirements must be met. Warranty Glacier Bay Water Filtration Systems Systems- Warranty Glacier Bay Water Filtration Systems are manufactured under the highest standards of quality and workmanship. Glacier Bay Wat Water er Filtration Systems warrants to the original purchaser that this system will be leak and drip free d during uring normal domestic use for a period of one (1) year from date of purchase. If this system should ever develop a leak or dr drip ip Glacier Bay Water Filtration Systems will free of charge provide the parts necessary to put the system back in good working cond condition. ition. A replacement for any defective part will be supplied free of charge for installation by the purchaser. Defects or dam damage age caused by use of other than authorized parts are not covered by this warranty. This warranty shall be effective from date of pu purchase rchase as shown on purchaser’s receipt. Glacier Bay Water Filtration Systems shall be installed per the manufacturer’s instal installation lation instructions and specifications. Some states do not allow limitations on how long a warranty lasts, so the above limitation may not apply to you. This warranty is valid for the original purchaser only and excludes industrial, commercial, or business use of the product, product misuse, and product damage due to installation error, whether performed by a contractor, service compa company, ny, or yourself. Glacier Bay Water Filtration Systems will not be responsible for labor charges or for damage incurred during installation, repair or replacement, nor for incidental or consequential damages. Some states, provinces and nations do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusions or limitations may not apply to you. Glacier Bay Water Filtration Systems will advise you of the procedure to follow in making warranty claims. Simply write to Gla Glacier cier Bay Water Filtration Systems at the address below. Explain the defect and include proof of purchase and you name, addre address ss and telephone number or you can also call us at 11-800-247 247-1087. U.S.A Glacier Bay Water Filtration Systems 2455 Paces Ferry Roa Road, N.W Atlanta, GA 30339 30339- 201 01-8401500 (Revv 0 00) Canada Glacier Bay Water Filtration Systems 900 900-11 Concorde Gate Toronto, ON M3C 4H9 H HOMEDEPOT.COM M/GLACIERBAY Please ase contact 1-800-2 247-1087 for furth rther assistance.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project