OROPY 18QJ1204*1/DRLYM Coat Hook Installation Manual


Add to my manuals
1 Pages

advertisement

OROPY 18QJ1204*1/DRLYM Coat Hook Installation Manual | Manualzz

Step 1: Adjust the product to the required width, then make 4 marks through the gasket holes on the wall by pencil.

Step 2: Punch holes by hand drill (6mm drill bit) on the marks of the wall (if installing surface is wood, ignore this step)

Step 3: Put the expansion bolts into the holes (if installing surface is wood, ignore this step). Place the product on the wall at the correct place, then tighten nuts into the expansion bolts or tighten nuts into the marked places if the surface is wood by screw-driver.

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement