BWE 6556-ORB Touch On Faucet Installation Manual

BWE
BEST WATER EXPERIENCE
DESCRIPTION
* Brass construction
e Flexible supply lines with 3/8”
fittings
e Includes Red/Blue indicators
CARTRIDGE
e Ceramic disk cartridge
STANDARDS
e Certified to CUPC
e Certified to AB1953
e Certified to NSF/ANSI 61
* ADA © for lever handle
7. 28inch
Specifications
Single-Handle Lavatory Faucet
NOTE: THIS FAUCET IS DESIGNED TO BE
INSTALLED THRU 1 HOLE /3 HOLES.
NSF/ANSI 61 LOW-LEAD
Toe ws Uy
==" Li a
PE ais Pinch
2. linch
=
CRITICAL DIMENSIONS
Single-Handle Lavatory Faucet Installation
INSTALLATION MANUAL Tools You Will Need :
a ; >
up ©
Adjustable wrench ~~ Hexagon wrench
wrench glasses
Notes before installation :
1.Please check that all components
are present.
2.Before installation ensure that all
feed lines are clear of debris and
on/off valve is present.
3.Ensure water pressure is between
20-125 PSI (includes combination
of hot and cold feed lines).
4.Pictures in the manual are
general in content and may not
represent exactly your purchased
faucet. If you are having
difficulties please contact a
professional plumber.
5.1f you will be away from home
for an extended period you should
shut off the main water supply.
Daily maintenance
1.Use a soft cloth and vinegar to
remove hard-water spots.
2.Check aerator (if present)
regularly for calcium build up are
when water stream is not
optimum.
3.DO NOT use caustic cleaning
products as the use will break
down finish and will void the
product warranty.
4.Acceptable cleaners include
vinegar or mild non-abrasive
liquid detergents.
5.If the water pressure appears to
be less than optimum remove,
inspect,clean or replace aerator.
2. Screw and hand tighten the hot and
cold flexible hoses to the faucet.DO
NOT use a wrench to tighten hoses as
this may damage the hose and/or the
hose threads.
1. Remove the rubber washer,metal
washer and locking nut from the
faucet.
4. Re-install the rubber washer followed
by the metal washer and lock-nut.Hand
tighten then tighten further using a
screw driver to tighten lock-nut screws.
3. Install faucet through center hole .
Warning
Is NO TAPE NEEDED FOR INSTALLATION
Run the hot and cold valve
at least 15 seconds to
J COLD clear it before connect
CS Noise could be significantly
HOT reduced by adjusting the
5.Attach flexible hose to water supply. — [Yalve water flow
1-1 Installation Sketch
1-2 Installation Steps
With Overflow Without Overflow Vessel Sink/Drain Installation (Overflow)
—_ ==
2)
€)
&
5)
®
®
®
Overflow
Channel
NOOO NN
|
— 2
Installation as shown in the figure
Vessel Sink/Drain Installation (non-Overflow)
DOTE
1) Drain Cap 7 Silicon Gasket Counter Top
@ Silicon Gasket
8) Plastic Washer
3) Sponge Gasket (9 Brass Locking Nut =—=-— ®
(4 Silicon Gasket 10 Rubber Gasket — т
(5) Drain Body (1 Locking Nut nn
(6 Overflow 12 Tail Pipe [+ ©
Installation as shown in the figure