BWE Oil Rubbed Bronze Waterfall 8-16 Inch Commercial Two Handle Widespread Bathroom Sink Faucet Touch On Faucet Installation Manual

BWE
FR EXPERIENCE
DESCRIPTION
e Brass construction
* Flexible supply lines with 3/8”
fittings
* Includes Red/Blue indicators
CARTRIDGE
* Ceramic disk cartridge
STANDARDS
e Certified to CUPC
e Certified to AB1953
e Certified to NSF/ANSI 61
e ADA for lever handle
3.94 inch
3.3inch
1.97 ==
Specifications
Two-Handle Widespread Faucet Installation
Dos
3. 15inch
CRITICAL DIMENSIONS
Two-Handle Widespread Faucet Installation
=| | CT
Adjustable wrench Hexagon wrench
INSTALLATION MANUAL Tools:
A
wrench
glasses
Notes before installation :
1.Please check that all components
are present.
2.Before installation ensure that all
feed lines are clear of debris and
on/off valve is present.
3.Ensure water pressure is between
20-125 PSI (includes combination
of hot and cold feed lines).
4.Pictures in the manual are
general in content and may not
represent exactly your purchased
faucet. If you are having
difficulties please contact a
professional plumber.
5.1f you will be away from home
for an extended period you should
shut off the main water supply.
Daily maintenance
1.Use a soft cloth and vinegar to
remove hard-water spots.
2.Check aerator (if present)
regularly for calcium build up are
when water stream is not
optimum.
3.DO NOT use caustic cleaning
products as the use will break
down finish and will void the
product warranty.
4.Acceptable cleaners include
vinegar or mild non-abrasive
liquid detergents.
5.If the water pressure appears to
be less than optimum remove,
inspect, clean or replace aerator.
PIE | али
14 LA
Run the hot and cold valve at least 15 (—)
seconds to clear it before connect k
Noise could be significantly
reduced by adjusting the
valve water flow
1-1 Installation Sketch
With Overflow
FENN Goh INES FD ES
© = oes в =
1-2 Installation Steps
Vessel Sink/Drain Installation(Overflow)
D Drain Cap
(2) Silicon Gasket
3) Sponge Gasket
A Silicon Gasket
5 Drain Body
6) Overflow
@ Silicon Gasket
8 Plastic Washer
‘9 Brass Locking Nut
10 Rubber Ggsket
a1 Locking Nut
12 Tail Pipe
233461
Installation as shown in the figur
Vessel Sink/Drain Installation (non-Overflow)
Г
7
Counter Top
—
| =
= Bema
12
Installation as shown in the figure