Dyconn Springfield Series Single Towel Hook User guide

Towel Bar Installation Guide
For Springfield Bathroom Accessory Series
Tools you will Need
Tool Checklist.
Install the Towel Bar
Follow these steps for installation.
1.
2.
2a.
Approx. 23.5”
Using a level and measuring tape,
measure the distance between mounting
plates. Mark screw points with tip of
screwdriver or pencil.
2b.
Prepare fastener holes for attaching
the mounting plates using options below:
A. Attaching to stud in drywall.
B. Attaching to drywall.
3.
Attaching to stud in drywall:
Use drill bit smaller than the screws to
pre-drill holes.
4.
Side View
Attaching to drywall:
Use drill size appropriate for wall
anchors. Tap each anchor in wall with
hammer.
Attach each mounting plate to wall by
installing screws into pre-drilled wall
anchor holes.
Assemble the towel bar and attach the
towel bar ends to the mounting plates.
Push the ends into the wall and then
downward, securing the towel bar.
5.
Important: Please use the provided beige wall anchors for drywall-only
installation. To use, follow the above-referenced steps, but concurrently
screw in both screw and beige wall anchor into wall.
For installation on tile surface/wall, please seek professional assistance at
your local hardware store or consult a licensed contractor. Please note tile
installation requires a tile drill bit.
The towel bar is now securely in place.
www.dyconnfaucet.com