Rubbermaid 1780151 FastTrack White Shelving Upright Installation Guide

Shelving & Bracket Install Tips
Follow these steps to properly install wire shelving into Fasttrack closet brackets
STEP 1
STEP 2
(Figure 1)
Start by inserting the brackets in the desired location
on the Fasttrack uprights. Insert the top tabs first and
then lock it in by pushing it down towards the wall.
Ensure that the bottom tabs are securely inserted into
the slots on the upright. (Figure 1)
STEP 3
(Figure 2)
Place your shelf on the brackets so that the front of the
shelf is resting on the front of the brackets. (Figure 2)
STEP 4A
Insert into center slot
(Figure 3)
Grab the rear of the shelf and flex it up slightly while
holding the front of the shelf against the front of the
brackets. (Figure 3)
STEP 4B
(Figure 4A-12 inch shelf )
Line up the shelf with the slots on the bracket and place
the center wires of the shelf into the slots. (Figure 4A & 4B)
STEP 5
Insert into both slots
(Figure 4B-16 inch shelf )
For deep shelving (16” or 20”), secure the shelf within
the slots in two places. (Figure 4B)
Rubbermaid Incorporated, Huntersville, NC USA 28078-1801
U.S.A. 1-888-895-2110 Canada 1-866-595-0525
www.rubbermaid.com
Insert into rear slot
(Figure 5)
Once the shelf is in the slots, push the shelf towards the
wall to secure the back wire into its slot. (Figure 5)
Your shelf is now installed. Repeat this process for any
additional shelves you wish to place in this system.