Attic Ease Pull System Kit User guide

Attic Ease Pull System

Installation Tools Needed:



Pocket knife or scissors



Pliers

 Power Drill



¼” Drill bit

Instructions:



Lower Attic Door.



Cut off existing cord.

 Drill ¼” hole where string was mounted (if required).



Insert the Fashion Pull-Ring through the ¼” hole on the exterior side of the

Attic Door. Hand-tighten the fastener and washer assembly. Use pliers to tighten set screw.



Raise the door back in place by inserting the hook of the Attic-Ease Reach Hook into the Fashion Pull-Ring.

 Locate a convenient place to store the Attic-Ease Reach Hook. A hall closet is usually ideal. Place the Reach Hook in the stowing position and mark where the storage hook should go.

 Hand turn the hook into position. Hang up your Attic-Ease Reach Hook.