Aeg L8FEC866R Quick Guide

QUICK USER'S GUIDE
A Before you activate the appliance
read the Safety Information chapter
in the User Manual.
y Ea
0
Ce
IL, =
ав
— a
N Before you activate the appliance Detergent dispenser Option buttons
remove all the transit bolts. On/Off button KA Skip phase button
(1) For more information please always Programme dial Start/Pause button
refer to the User Manual. Display
THE ON/OFF BUTTON THE DETERGENT DISPENSER DIE
The On/Off function automatically
deactivates the appliance to stop energy
consumption:
Before touching Start/Pause button,
if not using the appliance for about five
minutes. All settings are cancelled.
Press On/Off button to activate it again.
After five minutes from the end
of the programme. Once activated
the appliance again, the display
shows the cycle end.
U! ] Compartment for prewash and soak phase. CO
Ul] Compartment for wash phase.
68 Compartment for liquid additives.
«ZOO Flap for powder A (position up) or liquid
detergent &\ (position down).
INTERACTIVE DISPLAY
-— ey ce
Sra
40
w=) nt Vaux
40 1200 ww +0
(kg Maximum load indicator.
MAX Itflashes in case of overloading.
O Delay start indicator.
0 Door lock indicator and E child lock indicator.
nan hs area can show:the programme duration O0
e delay time 2h, the cycle end [J, the warning code ECU.
= + appears when Soft Plus option is active.
200 Spin speed indicator.
UM Temperature indicator and X- cold wash.
Option indicators:
[|] Rinse Hold dB Quiet @> Time Save
12] Stain +1 Extra Rinse
Ll] Prewash
Phase indicators:
LI Washing
ap Steam
Ez Rinse
y Anticrease
Spin
Oko-Mix
THE PROSENSE LOAD DETECTION
After the programme start and before the water filling,
the appliance estimates the laundry amount in 30 seconds.
The kg and . indicators flash. After load estimation,
the programme duration is updated accordingly on the display.
If the drum is overloaded, the display shows the maximum load
and MAX flashes. In this case, for further 30 seconds
it is possible to pause the appliance and remove a few garments.
If the laundry amount is not reduced, the appliance starts
the washing programme immediately despite the overload
(for more information see the User manual).
ALARM CODES
The display can show alarm codes
(refer to the “Troubleshooting” table in the user manual):
E10: The appliance does not fill water properly.
£20: The appliance does not drain the water.
E40: The appliance door is open or not closed correctly.
EFO: The anti-flood device is on. Disconnect the appliance and
close the water tap. Contact the Authorised service centre.
START THE APPLIANCE
DAILY USE
1.
5.
Open the water tap and connect the mains plug
to the mains socket.
Press On/Off button to activate the appliance.
Put the laundry in the drum, one item at a time. Make sure that
no laundry stays between the seal and the door.
Close the door and put the detergent and additives
in the correct compartment of the dispenser.
Turn the programme dial to set a programme.
The corresponding indicator comes on.
E.g. Synthetic programme at 40°C, 1200 rpm, 4 kg
6.
The display shows the maximum (um
declared load, the default Lik
temperature, the maximum ENG,
spin speed, the washing phase
indicators (when available) and 4 (200
the programme duration.
To change the temperature and/or the spin speed
or to add the available options touch the related buttons.
If necessary, set the delay start function. Keep touching
the Delay Start button until the display shows
the desired delay time.
Touch Start/Pause button to start the programme.
The Prosense function starts the load estimation. If you have
set the Delay Start, the appliance starts the count down.
During the programme, the appliance can adjust
the duration, depending on the water absorption
of the fabrics.
9. At the end of the programme the appliance stops automatically.
In the display all washing phase indicators become steady and
the time area shows a steady U. The indicator of the Start/Pause
button and the door lock indicator ==) goes off. The door unlocks.
If you have set the Rinse Hold or Quiet option, refer to'At the end
of the programme’ chapter in the User Manual.
10. Remove the laundry from the appliance. Make sure that the drum
is empty. Keep the door and the detergent dispenser slightly ajar
to prevent mildew and odours.
11. Unplug the appliance and close the water tap.
AFTER PROGRAMME START
If it is necessary to interrupt a programmme, touch Start/Pause
button and wait for the door unlock. Touch it again to restart
the programme.
If it is necessary to cancel a running programme, press the On/Off
button to deactivate the appliance. The selection is cancelled.
CARE AND CLEANING
Clean the appliance filter
regularly. Refer to ‘Careand
Cleaning’ chapter in the
user manual.
OcOcSc-V-060€£€0ZSL
‘sJoyoe( UMOPp ‘sjoanp ‘saujojo papped ‘“Joyue|q onayjuAs ajbulg pIo9 - 9. 09 }eANG
‘сшеэу Jejiwis pue Buibbol “BuiyoAo “LÁB se yons sauyjojo sOds илероу\ pIo9 - 9. 07 JOOPINO
‘ulom 89U0 JO pajlos ÁNUBDIL sue): oljeyyuÁs pue UOHOI 9. 0€ - 9, 07 BY € “UIN OZ
semsus aunuesbord sul “sun oneujus Inojoo-jsej pue vono5 9, 08-9, 09 9MOdO O
souwuwel Bold Buiysem
"SWeyl 91)AUIUÁS pue uoyo9 1Oj sWILUBJBO.Id wesjS - wea)g
эшшелбола шеэ) с
ejeolep pue ¡com e|jgeysem puey joom sjgeysem sulyoen PIO9 - J, OF AIS/IOOM
10$ [eLUJOU YM SWSY 1e)SSÁJOd “esoasiA “SANÁJOE SE Yans SOIQej ejeo1eg PIO9 - 2, 07 sejeo!eg
"11OS JeWWIOU YM SUSY 9110ej paxitu JO SUIS OHOUIUAS PIO9 - Э. 09 SoIOUJUAS
IOS JeWJOU YJIM UONOS panojoo pue uoyoo siUNM PIO9 - D. S6 suono9
‘sjuouleÉ pojlos AJjeu1loN ‘suonOoO panojos pue ouymM Э.05 - 2.09 09-0 093
сэшшелбола Gurysem
peoj jo adA1 эбиел элпуелэйше | эшшелбола
SINNVUDOWd