V-ZUG 34003 Warming drawer WS 60-144 Installation Guide

Installation instructions

Warming drawer 60-144

J34003.113-0

18.7.12 FUW

The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order specified.

Validity

These installation instructions apply to the model: 34003

General notes

If fitting in flammable material, the guidelines and standards for low voltage installations and for the fire protection must be strictly observed.

Identification plate

A Remove the drawer. The identification plate is located on the left-hand side next to the dial.

Electrical connections

Electrical connections must made by qualified personnel in accordance with the guidelines and standards for low voltage installations and the specifications of the local electricity supply companies.

A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. An all-pole mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and socket devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching are permissible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and fault-free operation. After installation, live parts and cables with basic insulation must not be accessible. Old installations should always be checked.

Refer to the identification plate for specifications for the required mains voltage, current type and fuses.

Application height of the appliance: up to max. 2000 m above sea level

Installation

The drawer must be secured by 4 screws to prevent tipping.

Ensuring that the mains cable is not pinched. After installation, the mains cable must not touch the back and the bottom of the appliance.

1. Fix a bracket set 60 W (not included in the scope of delivery) for an appliance located above or below.

2. Place appliance in front of the niche and connect mains cable.

3. Carefully slide appliance into the niche until it is flush with the front of the cabinets, ensuring that the mains cable is not pinched.

4. Open the drawer and fix in place from the front, using the 4 supplied screws S .

W

S

1

Installation instructions

Warming drawer 60-144

Built-in solo

J34003.113-0

18.7.12 FUW min. 550

560–568

600

596

547

Installation combinations

If a second appliance is installed in the same niche (above or below), you should use bracket set 60 W to support the upper appliance.

Below a oven

X

X

Detail X min. 550 min. 55

0

50 W

560–568

50 W

560–568

2