Service
- Tia
Co =
En e
el
Es
SPA CS Pad
Г] в
К]
М e
cu, LE
&
a 7 ha. >
WASHER “=
+ д)
Li
= j
LU А
of I Ц
a 7 E
ha FR Tes, te
ER Ч Ea
Fort or ies An ag Ы Ч, ha Y
Re я E
HR ; a =F an
ve,
F VA pe
EVE
HALF-ROUND
HOLES
TO UNASSEMBLE
Twist spooi (7) to position lugs {A & B}
beiween two hati-rounded holes {C & О).
“ull up, separating spool from housing.
| TO REWIND Spool
Use one line 20" long. Thread end of line
through eye on spool and pull through until
line is the same length on both sides of eye.
Wind both ends of line in same direction as
trimmer rotation. Wind tightly and evenly: from
side to side and do not twist line. ~~ |
(Ignore the ridge.)
To REASSEMBLE
Pass end of line through either eyelet on
housing being carefui not to let fine slip under
spool. Line up slots under spool with lugs on
Outer drive (5) and push together. Twist spool
so lugs lock into haif-round holes. The lugs
can be locked in elther a clockwise or counter-
clockwise direction. If inner cam and driver
start to loosen, twist in other direction to lock.
CAUTION - ALWAYS WEAR PROTECTION FOR THE
EYES WHER USING ANY WEED CUTTING EQUIPMENT.
">
