- Home
- Domestic appliances
- Small kitchen appliances
- Toasters
- Vollrath
- Butter Wheel
- Installation instructions
Vollrath Butter Wheel Installation Instructions
Add to my manuals
4 Pages
Vollrath Butter Wheel is a device that can be easily installed on top of your toaster. It allows you to butter the buns or slices of bread without the need to take them out of the toaster. The butter wheel assembly can be disassembled for easy cleaning. It is important to note that you should only butter the side of the bun that will face the platen and avoid applying butter to both sides as this could damage the toaster.
advertisement
▼
Scroll to page 2
of 4
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 1 Butter Wheel
- 1 1. Remove the top of the toaster by unscrewing the thumb screws on the sides.
- 1 2. Place the butter wheel assembly parallel to the slot, and on the left side of the toaster cover.
- 1 3. Rotate the butter wheel assembly to be perpendicular to the slot to secure it into position.
- 2 4. Place the cover with the attached butter wheel on top of the toaster. The butter wheel should be opposite the control panel.
- 2 5. While holding down the top of the toaster, re-install the thumb screws that hold the top in place. Note: Thumb screws must be tightened to engage the safety interlock switch under the cover. If screws are not tightened, the toaster will not operate.
- 2 1. Place butter in the tray.
- 2 2. Butter the side of the bun that will face the platen by rolling the bun over the wheel.
- 2 3. Insert the bun halves into the toaster with the buttered side facing the platen.
- 3 1. Let the toaster and butter wheel assembly cool completely.
- 3 2. Remove the cover.
- 3 3. Remove the butter wheel assembly from the cover and disassemble.
- 3 4. Wash the butter wheel assembly components in warm, soapy water.
- 1 Roue à beurre
- 1 1. Enlevez le haut du grille-pain en dévissant les vis à oreilles sur les côtés.
- 1 2. Placez la roue à beurre parallèlement à la fente, et à gauche du grille-pain.
- 1 3. Tournez la roue à beurre de manière à ce qu'elle soit perpendiculaire à la fente pour la fixer en position.
- 2 4. Placez le couvercle avec la roue à beurre attachée sur le haut du grille-pain. TLa roue à beurre doit être à l'opposé du panneau de commande.
- 2 5. Tout en tenant le haut du grille-pain, réinstallez les vis à oreilles qui le maintiennent en place. Remarque : Les vis à oreilles doivent être serrées pour enclencher l'interrupteur d'interverrouillage de sécurité sous le couvercle. Si les ...
- 2 1. Placez le beurre dans le plateau.
- 2 2. Beurrez la face du petit pain qui sera face à la plaque en faisant rouler le petit pain sur la roue.
- 2 3. Insérez les moitiés de petit pain dans le grille-pain, la face beurrée tournée vers la plaque.
- 3 1. Laissez refroidir complètement le grille-pain et la roue à beurre.
- 3 2. Enlevez le couvercle.
- 3 3. Enlevez la roue à beurre du couvercle et démontez.
- 3 4. Lavez les composants de la roue à beurre dans de l'eau savonneuse chaude.
- 1 Untador de mantequilla
- 1 1. Retire la parte superior de la tostadora desenroscando los tornillos de mano en los lados.
- 1 2. Coloque el conjunto del untador de mantequilla paralelo a la ranura y en el lado izquierdo de la tapa de la tostadora.
- 1 3. Gire el conjunto del untador mantequilla de modo que quede perpendicular a la ranura a fin de asegurarlo en su posición.
- 2 4. Coloque la tapa con el untador de mantequilla fijo en la parte superior de la tostadora. El untador debe estar opuesto al panel de control.
- 2 5. Mientras sostiene la parte superior de la tostadora, vuelva a instalar los tornillos de mano que sujetan la parte superior en su lugar. Nota: Deben apretarse los tornillos de mano para enganchar el interruptor de interbloqueo de seguridad debajo d...
- 2 1. Coloque la mantequilla en la bandeja.
- 2 2. Unte con mantequilla el lado del pan que estará orientado hacia la platina. Para ello haga rodar el pan sobre la rueda.
- 2 3. Introduzca las mitades del pan en la tostadora con el lado con mantequilla orientado hacia la platina.
- 3 1. Deje que la tostadora y el conjunto de untador de mantequilla seenfríen completamente.
- 3 2. Retire la tapa.
- 3 3. Retire el conjunto del untador de mantequilla de la tapa y desmóntelo.
- 3 4. Lave los componentes del conjunto de untador de mantequilla en agua tibia jabonosa.