Midmark Synthesis® Tables Installation Manual

Wet or Dry Treatment Table Conversion Kit

Attention

New door and Nutsert Tool required for conversion, contact Midmark at 1-800-643-6275.

Note

Wet table conversion shown, follow same procedure for dry table.

Applies to Models:

VT

Special Tools:

Nutsert Tool - 002-0521-00

© 2019 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 | midmark.com

1

Style A

004-10225-00 Rev. AA1 (1/7/2020)

Step 1:

Remove door from hinge plate by squeezing tab at back of hinge.

Step 2:

Remove hinge plates (2) from table by removing screws (4).

Step 3:

Remove drawers from table by pulling drawers completely out, pull sides of drawer away from glides and pull up and out.

© 2019 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 | midmark.com

English-2

Step 4:

Mark drawer glide position before removing. Remove drawer glides from both sides of inside of table. Remove screw (1) from front of each glide and pull glide forward from back slot.

Equipment Alert

Midmark recommends 2 installers to install back panel.

Equipment Alert

Midmark recommends 2 installers to prevent damage to back panel.

Step 5:

Remove back panel by removing screws (8) from inside table.

Step 6:

Install back panel on opposite side of table secure with screws (8) from inside of table.

Step 7:

Install drawer glides into opposite side of table as shown in same position as marked.

Angle back of slide with tab when placing into slot in table frame. Rotate front of slide up and secure with screw (1).

© 2019 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 | midmark.com

English-3

Step 8:

Install drawers by sliding drawer glides out and slide back of drawer under tabs in back of slide. Push down on front of drawer to insert front tabs on slides in drawer slots.

Step 9:

Install nutserts (4) and hinge plates onto table on opposite side of table.

Step 10:

Install new door onto hinge plates.

Step 11:

Completed tables shown above.

© 2019 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 | midmark.com

English-4