advertisement
INSTALLATION INSTRUCTIONS
SLIDE BAR ASSEMBLY
MODEL NO. 292
Recommended Installation by a Professional Plumbing Contractor
Locate the desired position of slide bar on finished wall. See Fig. 1.
Mark wall and drill 5/16” hole for WALL ANCHORS (1) to dimension shown in Figure 1.
Place SLIDE BAR (2) into END POST (3). Note: Large diameter hole in
SLIDE BAR (2) must face out as shown in Figure 2.
Place POST (3) onto ESCUTCHEON (4), insert SCREW (5) & securely tighten into ANCHOR (1) as shown in Figure 2.
Press END CAP (6) into end of POST (3).
1 23”
Figure 1
Slide and lock HOLDER ASSEMBLY (7) onto SLIDE BAR (2) and repeat the above steps to the other end of SLIDE BAR (2) as shown in Figure 3.
5
2
4
1
3
4
1
6
5
3
7
2
6
Figure 2
Figure 3
(949) 417-5207
NWP-292 Santa Ana, Ca. 92705 10/10/2011 www.brasstech.com
advertisement