Prastel EASY-DT Keypad User Guide

EASY-DT : SIMPLIFIED USERGUIDE
ISEASY-DT_EN_09_18.pdf
Enter the setting mode
Technical overview:
Power supply: 12-24 VAC or VDC
Average Work consumption: < 30mA
Rest consumption: < 160mA
Frequency: EM125KHz
Number of relay output: 2
Working conditions: -30°C - +70
IP66
Size / Weight: 76 X 120 X 22
Modify
administrator code
POWER
SUPPLY
RELAY 1
RELAY 2
Input the new 4-digit admin code twice.
2
Enter the setting mode .
Input memory rank number 000 to 999 (3 digits)
Relay 1 add user
card and code
Red /+
=+
= Common 1
White / NO 1
= NO contact 1
= Common 1
= NC contact 1
} NO1
} NC1
Purple / COM 2
Blue/ NO 2
= Common 2
= NO contact 2
} NO2
Purple / COM 2
Grey / NC 2
= Common 2
= NC contact 2
} NC2
Input the master code twice.
(default code : 1234)
Press the button
Free rank
Occupied rank
(4 digits by default)
Relay 1 activation
time
 Select menu 1 by pressing :
*
1
 Input the delay time in seconds from 00 to 99
(2 digits)
2
.
1
.
Relay 2 add user
card and code
*
4
Input memory rank from 00 to 09 (2-digits) :
 Input the user card/code for the Relay 2
(4 digits by default)
Pink / COM 1
Pink / COM 1
Aqua / NC 1
Occupied rank
Quit the setting mode 2 .
Enter the setting mode 1 .
Enter the setting mode
} 12-24 VAC or VDC
Free rank
Input the user card/code for the Relay 1
Quit the setting mode
= GND
3
.
 Select menu 4 by pressing :
Black / -
*
1
Wiring diagram:
Quit the setting
mode
.
Select menu 3 by pressing :
Quit the setting mode
= Proximity reading and
programming zone
Enter the setting
mode
1
#
twice.
Relay 2 activation
time
Quit the setting mode 2 .
Enter the setting mode 1 .
 Select menu 5 by pressing :
*
5
Input the delay time in seconds from 00 to 99
(2 digits)
Quit the setting mode
2
.
If a memory rank is occupied: Enter setting mode
 Input memory rank:
Delete one user card Relay1: from 000 to 999
Relay2: from 00 to 09
(3-digits) :
(2-digits) :
and code
 Erase the rank by pressing twice ::
Input admin code twice :
Clean all user cards
and codes & restores  Select menu 8 by pressing :
to factory defaults
Press the button 9 twice :
*
x2
5
*9
8
Shut off the power supply.
Reset administrator Turn on the power while pressing :
code
Keep pressing the button until it make a sound.
Legend:
= 1 short beep;
1
= 1 long beep;
:
x2
#
= flashing orange