Soundmaster SCD3750 Owner Manual

DEUTSCH

Hersteller

Wörlein GmbH Tel.: +49 9103/71670

Gewerbestrasse 12 Fax.: +49 9103/716712

D 90556 Cadolzburg Email. [email protected]

GERMANY Web: www.woerlein.com

PORTUGUÊS

ENGLISH NORSK

FRANÇAIS SVENSK

NEDERLANDS SUOMI

ESPAÑOL

SCD3750DS / SCD3750WS

ENVIRONMENTAL PROTECTION

Do not dispose of this product with the normal household waste at the end of its life cycle. Return it to a collection point for the recycling of electrical and electronic devices. This is indicated by the symbol on the product, user manual or packaging.

The materials are reusable according to their markings. By reusing, recycling or other forms of utilization of old devices you make an important contribution to the protection of our environment.

Please contact your local authorities for details about collection points.

CAUTION - INVISIBLE LASER RADIATION WHEN OPENING THE COVER OR

PRESSING THE SAFETY INTERLOCK. AVOID EXPOSURE TO THE LASER BEAM.

WARNING

Risk of electric shock

Do not open!

Caution: To reduce the risk of electric shock, do not remove the cover (or back). There are no user serviceable parts inside. Refer servicing to qualified service personnel.

This symbol indicates the presence of dangerous voltage inside the enclosure, sufficient enough to cause electric shock.

This symbol indicates the presence of important operating and maintenance instructions for the device.

Safety, Environmental and Setup Instructions

• Use the device in dry indoor environments only.

• Protect the device from humidity.

•

Do not open the device. RISK OF ELECTRIC SHOCK!

Refer opening and servicing to qualified personnel.

• Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with the specifications on the rating plate.

•

Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.

• Disconnect device warning: Main plug is used as the connection, so it should always remain ready operate.

•

The mains plug is used as the disconnect device, the disconnect device shall remain readily operable.

•

A damaged mains cable or plug must immediately be replaced by an authorized service center.

•

In case of lightning, immediately disconnect the device from the mains supply.

•

Children should be supervised by parents when using the device.

• Clean the device with a dry cloth only.

Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS!

•

Do not expose the device to direct sunlight or other heat sources.

• Install the device at a location with sufficient ventilation in order to prevent heat accumulation.

•

Do not cover the ventilation openings!

•

The ventilation should not be impeded by covering the ventilation openings with items, such as newspaper, table-cloths, curtains, etc.

• It shall be not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.

•

The unit should not be exposed to direct sunlight, very high or low temperature, moisture, vibrations or placed in dusty environment.

• Never attempt to insert wires, pins or other such objects into the vents or opening of the unit.

•

Install the device at a safe and vibration-free location.

• No naked flame sources, such as lighted candles, should be placed on the apparatus.

•

Install the device as far away as possible from computers and microwave units; otherwise radio reception may be disturbed.

•

Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized service/ customer center.

•

The device is equipped with a “Class 1 Laser”. Avoid exposure to the laser beam as this could cause eye injuries.

•

Only use mercury and cadmium-free batteries.

• Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.

•

Used batteries are hazardous waste and NOT to be disposed of with the household waste!!! Return the batteries to your dealer or to collection points in your community.

• Keep batteries away from children. Children might swallow batteries. Contact a physician immediately if a battery was swallowed.

•

Check your batteries regularly to avoid battery leakage.

Used batteries are hazardous waste and NOT to be disposed of with the household waste!

As a consumer you are legally obligated to return all batteries for environmentally responsible recycling – no matter whether or not the batteries contain harmful substances*).

Return batteries free of charge to public collection points in your community or to shops selling batteries of the respective kind.

Only return fully discharged batteries.

*) marked Cd = cadmium, Hg = mercury, Pb = lead

LOCATION OF CONTROLS

1 Speakers

2 CD Compartment

3 FOLDER UP Button

4 CD/USB Button

5 PROGRAM Button

6 STOP Button

7 PLAY/PAUSE / Button

8 MODE Button

9 SKIP DN Button

10 SKIP UP Button

11 LCD Display

12 Handle

13 BAND Switch

14 FUNCTION Switch

15 TUNING Control

16 VOLUME Control

17 Aux-In Jack

18 Phone Jack

19 Antenna

20 AC Socket

21 Battery Compartment

22 USB Slot

- EN 2 -

AC OPERATION

Before operation, please make sure that the VOLTAGE mentioned on the unit is same as the voltage of your local area. Unravel the AC power cord, insert one end into the AC socket on the set, and the other end into a standard AC outlet.

ATTENTION

1. Do not plug or unplug the power cable while you have wet hands.

2. When planning not to use this unit for a long time, disconnect the power cable from the wall outlet.

3. When disconnecting the power cord from the wall outlet, do not pull on the cord in order to avoid shock risks caused by damaged cable.

BATTERY OPERATION

Disconnect the AC cord set completely. Open the battery compartment door and insert 6 pieces UM-2 "C" size batteries into the battery compartment with battery polarity as shown inside the battery compartment.

RADIO OPERATION

1. Set the FUNCTION switch to FM ST or FM position.

2. Rotate the TUNING control to tune to your desired radio station.

3. Adjust the sound level by rotating the VOLUME control.

4. To turn off the radio, set the FUNCTION switch to OFF position.

Note: When turn to a FM stereo broadcast the "FM ST." will be shown on the display.

ANTENNA

For best reception, fully extend the FM Antenna to receive FM stations.

STEREO HEADPHONE JACK

For private listening, insert the plug of a stereo headphone into the phones jack and adjust the VOLUME CONTROL accordingly. During the use of a headphone, the speakers are automatically disconnected.

MP3/AUX IN CONNECTION

1. Set the FUNCTION switch to CD/USB/AUX or STORY/AUX position.

2. Insert one side of the audio cable (requires 3.5mm stereo plug, not supplied) into the line-out jack or phones jack on your MP3 player and the other side to the aux-in jack on the unit.

3. Turn on your MP3 player and follow the playback instruction.

4. Adjust the VOLUME Control to the desired volume level.

5. To stop this function, simply turned off your MP3 player.

- EN 3 -

CD/MP3/USB OPERATION

Playing Audio CDs

1. Set the FUNCTION switch to CD/USB/AUX position.

2. Press the CD/USB button to select CD mode, CD icon will appear on the LCD display.

3. Insert a CD disc in the CD compartment and close the CD door, the unit will start reading the disc and will play automatically.

4. During playing, press the PLAY/PAUSE button to temporarily pause playing. To resume, press the PLAY/PAUSE button again.

5. Adjust the VOLUME Control to the desired volume level.

6. To stop playing the CD, press the STOP button.

Playing MP3 Discs

1. Set the FUNCTION switch to CD/USB/AUX position.

2. Press the CD/USB button to select the CD mode, MP3 icon will appear on the LCD display.

3. Insert a MP3 disc into the CD Compartment and close the door, the unit will start reading the disc and will play automatically.

4. If your MP3 disc has folders, you can use the FOLDER UP button to select the desired folder.

5. During playing, press the PLAY/PAUSE button to temporarily pause playing. To resume, press the PLAY/PAUSE button again.

6. Adjust the VOLUME Control to the desired volume level.

7. To stop playing the CD, press the STOP button.

Playing MP3 files with USB device

1. Set the FUNCTION switch to CD/USB/AUX position.

2. Press the CD/USB/SD button to select the USB mode, USB will appear on the LCD display.

3. Plug your USB device into the USB port on the unit, the unit will start reading the files in the USB device and play automatically.

4. If your USB device has folders, you can use the FOLDER UP button to select the desired folder.

5. During playing, press the PLAY/PAUSE button to temporarily pause playing. To resume, press the PLAY/PAUSE button again.

6. Adjust the VOLUME Control to the desired volume level.

7. To stop playing the files in the USB, press the STOP button.

Note:

Because of non-standardized format definition/production of MP3 format, playback quality

& performance are not guaranteed.

Manufacturer is not responsible for the playability of MP3 in any case due to recording conditions such as PC performance, writing software, media ability and etc.

- EN 4 -

Skip Mode

1. During play or pause mode, press the SKIP UP button to go to the next track.

2. During play or pause mod, press the SKIP DN button to go back to the previous track.

Different Play Mode

Press the MODE button to select different kinds of play mode with the following sequence.

For Audio CDs : Repeat 1 Repeat All Random Normal

For MP3 Files : Repeat 1 Repeat Folder Repeat All Random Normal

Repeat 1 – repeat the track being played.

Repeat All – repeat all the tracks in the storage media.

Repeat Folder – repeat the tracks in the entire folder.

Random – play the tracks in the storage media in random order selected by the player.

Normal – play the tracks in sequence.

Programming

In case of Playing Audio CD

The programming should be done during STOP mode

1. Press the PROGRAM button, the LCD display will show P01 and flash.

2. Use the SKIP UP or SKIP DN button to select the desired track.

3. Press the PROGRAM button again to store the selected track in the memory, the LCD display will show P02 and flash continuously.

4. Repeat steps 2 to 3 to store more tracks in the memory. You can store up to 20 tracks in the memory.

5. Press the PLAY/PAUSE button to start playing the disc in the programmed order.

6. To stop playing, press the STOP button.

7. To cancel the programming list, press the STOP button and set the FUNCTION switch to OFF position.

In case of Playing MP3 Files

All procedure is same as Audio CD. But if you have folders in your storage device, you can select folder/album and track both. You can store up to 99 tracks in the memory.

Resume Function (continue from ended audio point)

Set the FUNCTION switch to STORY/AUX position. Then, the unit can memorise when the music is stopped before switching to other function/switching off.

Set the FUNCTION switch to STORY/AUX position again. The music will continue from the ended point.

Note:

If the AC power cord/USB device/Disc is removed, the memory will be lost.

- EN 5 -

Important Note

Automatic standby switching

To comply with the ERP2 directive, the unit automatically switches to standby after approx..

10 minutes without a signal. To switch the unit on again, press the “PLAY/PAUSE” button on the unit.

CARE AND MAINTENANCE

Always turn off the unit after use.

Keep the unit away from magnetic objects, water or heat sources.

Use a clean soft cloth moistened with lukewarm water to clean the cabinet. Never use chemical cleaners that could damage the finish of the unit.

Never touch the CD pickup and lens. If fingerprints get on the pickup lens, clean it gently with a commercial lens cleaner.

Disconnect the unit from any power sources before cleaning.

To remove a disc from its storage case, press down on the centre of the case and lift the disc out, holding it carefully by the edges.

Fingerprints and dust should be carefully wiped off the disc’s recorded surface with a soft cloth. Unlike conventional records, compact discs have no grooves to collect dust and microscopic debris so gently wiping with a soft cloth should remove most particles.

Wipe in a straight line from the inside to the outside of the disc. Small dust particles and light stains will have absolutely no effect on reproduction quality.

Never use chemicals such as record sprays, anti-static sprays, benzene or thinners to clean compact discs. These chemicals can irreparably damage the disc’s surface.

Discs should be returned to their cases after use. This avoids serious scratches that could cause the Laser pickup to skip.

Do not expose discs to direct sunlight, high humidity, or high temperatures for extended periods. Long exposure to high temperatures can warp the disc.

Do not stick paper or write anything with a ballpoint pen on the label side of the disc.

SPECIFICATIONS

Frequency Range:

Power Supply:

FM 87.5 - 108 MHz

AC 230V ~ 50Hz

DC 9V (UM-2 x 6)

Specifications are subject to change without further notice.

- EN 6 -