SVC 1086TQ 4AAAA ECO POWER
Copyright © 2019, Fast ČR, a.s.
EN Bagless vacuum cleaner
Translation of the original manual
- 1 11/2019
EN
Bagless vacuum cleaner
Important safety instructions
READ CAREFULLY AND STORE FOR FUTURE USE.
■ This appliance may be used by children 8 years of age and older and by persons with physical or mental impairments or by inexperienced persons, if they are properly supervised or have been informed about how to use the appliance in a safe manner and understand the potential dangers. Children must not play with the appliance. Cleaning and maintenance performed by the user must not be performed by unsupervised children.
■ If the power cord is damaged, it must be replaced by the manufacturer, its service technician or by a similarly qualified person, as this will prevent a dangerous situation from arising.
■ Pull the power cable plug out of the power socket, before cleaning or performing maintenance on the appliance.
■ This vacuum cleaner is designed for use in households, offices and similar types of areas. Do not use in industrial surroundings.
■ Do not expose the vacuum cleaner to direct sunlight and do not place it near an open fire or appliances that are a source of heat.
■ Before connecting the power cord to a power socket, check that the technical details on the vacuum cleaner’s rating label match the electrical voltage in the socket.
■ Make sure the power cord is not touching a hot surface or sharp objects.
■ Do not submerge the vacuum cleaner under water or any other liquid and do not rinse it under running water.
■ Before turning on the vacuum cleaner, and outflow filters are installed in their place.
■ When the vacuum cleaner is running, ensure that the air vents and the suction hole are not blocked.
Do not use the vacuum cleaner to vacuum:
– smouldering cigarettes, burning items, matches or embers;
– water and other liquids;
– flammable or volatile materials;
– sharp items, e.g. broken glass, needles, pins, etc.;
– flour, wall plaster, cement and other building materials;
– larger pieces of paper or plastic bags, which can easily block the suction hole.
– Vacuuming of some types of floors or floor surfaces can create a electrostatic discharge, which presents no danger to the user.
Copyright © 2019, Fast ČR, a.s.
- 2 11/2019
■ Do not place the suction nozzle or tube against any parts of the face.
■ Always turn off the vacuum cleaner and disconnect it from the power socket when leaving it without supervision, after finishing using it and before cleaning it.
Disconnect the power cord from the power socket by pulling on the plug, never pulling on the cord. Otherwise, this could damage the power cord or the socket. It is recommended to hold the power cord in your hand when winding it up.
■ If the power cord is damaged, have it replaced at a professional service centre. It is forbidden to use the vacuum cleaner if it has a damaged power cord.
■ Do not use the vacuum cleaner if it is not working correctly, if it has been damaged or has been submerged in water. Do not repair the vacuum cleaner yourself or make any adjustments to it. Have all repairs performed at an authorised service centre. By tampering with the appliance, you risk voiding your legal rights arising from unsatisfactory performance or quality warranty.
Copyright © 2019, Fast ČR, a.s.
- 3 11/2019
A
11
12
13
SVC 1086TQ 4AAAA ECO POWER
4AAAA ECO POWER
3
4
5
1
2
6
7
8
9
10
Copyright © 2019, Fast ČR, a.s.
- 4 11/2019
14
16 17
19
Copyright © 2019, Fast ČR, a.s.
- 5 -
15
18
20
11/2019
21
22
Copyright © 2019, Fast ČR, a.s.
- 6 11/2019
EN
Bagless vacuum cleaner
User's manual
■ Prior to using this appliance, please read the user’s manual thoroughly, even in cases, when one has already familiarised themselves with previous use of similar types of appliances. Only use the appliance in the manner described in this user’s manual.
Keep this user’s manual in a safe place where it can be easily retrieved for future use.
■ We recommend saving the original cardboard box, packaging material, purchase receipt and responsibility statement of the vendor or warranty card for at least the duration of the legal liability for unsatisfactory performance or quality. In the event of transportation, we recommend that you pack the appliance in the original box from the manufacturer.
DESCRIPTION OF THE APPLIANCE
A1 Dust container release button
A2 Handle
A3 Automatic power cord winding button
A4 Suction power adjustment button
A5 On/Off button
A6 Rubber-coate d travel wheel
A7 Removable dust container
A8 Flexible hose end connection hole
A9 Flexible hose end
A10 Flexible hose
A11 Telescopic metal tube
A12 Floor nozzle with an extensible brush and DEEP cleaning and EASY cleaning switch
A13 Flap for extending and retracting the brush
A14 Crevice nozzle with an extensible brush
A15 Dust container open clip
A16 HEPA filter H13
A17 Removable grille
A18 Inflow micro-filter
A19 Cyclone unit
A20 Groove for the horizontal parking position
A21 Motor filter
A22 Long crevice nozzle
BEFORE FIRST USE
■ Before first use, take the appliance and its accessories out of the packaging material and remove all promotional labels and stickers. Check that neither the appliance nor any of its parts is damaged.
INTENDED USE OF THE ACCESSORIES
■ The universal floor nozzle with an extensible brush A12 is intended for all floor types. Extend the brush when vacuuming smooth hard floors, and retract it when vacuuming carpets. To extend and retract the brush, use flap A13 on the floor nozzle A12 . Floor nozzle A12 also has a switch for extending out a travel roller. This switch is located in the centre of the floor nozzle A12 and it has two positions - deep cleaning and easy cleaning. The deep cleaning position (the travel roller is retracted) is ideal for deep and thorough vacuuming of carpets. The easy cleaning position (the travel roller is extended) makes movement over the vacuumed surface easier. We recommend to slightly lift up the floor nozzle A12 when you wish to switch to the easy cleaning position.
■ The crevice nozzle A14 makes for easier vacuuming of corners, hard to reach places, and after extending the brush also furniture, upholstery, curtains, blinds, etc.
■ The long crevice nozzle A22 enables the vacuuming of dust and dirt from narrow, hard-to-reach places in corners or behind furniture.
PREPARING FOR USE
■ Check that the dust container A7 with the micro-filter A18 and cyclone unit A19 are properly installed in the vacuum cleaner.
■ Slide the end of the flexible hose A9 fully into the hole A8 . The hose A9 is secured in place when an audible click is made.
Note:
Prior to disassembly, it is necessary to press the latches on the hose end
A10 while simultaneously pulling it out of the hole A8 .
■ Attach the telescopic tube A11 on to the handle of the flexible hose A10 . Slide the clip on the telescopic tube A11 in the direction of the arrow marked on the extension locking clip on the telescopic tube A11 . Set the length of the tube A11 by sliding its extensible part in or out. When the clip is released, it will lock in at the set length.
■ Connect the floor nozzle A12 to the free end of the telescopic tube A11 .
■ The crevice nozzle A14 , or long crevice nozzle A22 can be connected directly to the handle of the flexible hose A10 or the telescopic tube A11 .
■ The flexible hose A10 , metal telescopic nozzle A11 , combination floor nozzle A12 , have a practical click-in system for simple and secure connection of the individual accessory parts. Accessories equipped with this system easily and quickly fit into each other; simply press the click-in system clip to release them.
USING THE VACUUM CLEANER
■ Pull on the power plug to wind out the required length of the power cord and connect it to a power socket.
Attention:
The yellow mark on the power cord indicates the approaching end of its length, and the red mark indicates the complete end of its length. Do not attempt to pull the power cord past this mark.
■ To start the vacuum cleaner, press the On/Off button A5 . Use button A4 to set the suction power of the vacuum cleaner.
■ The rubber-coated wheels A6 protect floating floors against scratching and ensure smooth motion of the vacuum cleaner on the floor.
■ When you have finished vacuuming, turn off the vacuum cleaner by pressing the
On/Off button A5 and disconnect the power cord from the power socket. To wind the power cord back into the vacuum cleaner, hold down button A3 until its entire length is wound up. Gently hold the power cord with one hand while winding it up.
Note:
If the power cord is not wound up completely, release button A3 , and pull the power cord out of the vacuum cleaner by approximately 50 cm and then try to wind it up again.
PARKING POSITION OF THE VACUUM CLEANER
When not using the vacuum cleaner, you may put it in the parking position by sliding the guide tab on the floor nozzle A12 into the groove A20 .
Do not carry the vacuum cleaner while it is in the parking position. Otherwise, the guide tab on the floor nozzle A12 could brake off.
CLEANING AND MAINTENANCE
■ Disconnect the power plug from the power socket before cleaning.
Warning:
To prevent the risk of injury by electrical shock, do not submerge the appliance, power cord or power plug in water or any another liquid.
Emptying and cleaning the dust container
■ We recommend regularly emptying and cleaning the dust container A7 .
■ In order to be able to remove the dust container A7 from the vacuum cleaner, push the dust container release button A1 and pull on the handle A2 to remove the dust container A7 from the vacuum cleaner. Position it over a dust bin and press the dust container open clip A15 . This will open the tilt-out bottom and dump out the contents of the container A7 .
■ Gently tap on the sides of the container A7 to release any accumulated dirt. For hygiene reasons, we recommend emptying out the dust container A7 away from living areas.
■ In order to clean the dust container A7 , hold it with one hand and with the other hand turn the handle A2 in the direction of the open padlock symbol that is marked on the dust container A7 . Take the inflow micro-filter A18 and the cyclone unit A19 out of the dust container A7 . Wash the container A7 under lukewarm running water and thoroughly wipe it dry. Assemble the container A7 and close its bottom. Then reinsert it back into the vacuum cleaner and make sure that it is properly secured in the vacuum cleaner.
Cleaning and replacing the HEPA filter, micro-filter and motor filter
■ To ensure the reliable operation of the vacuum cleaner, it is necessary to regularly clean and replace the filters. When filters are soiled, their effectiveness is reduced, which reduces the effectiveness of the vacuum cleaner.
HEPA filter
■ In order to clean and replace the HEPA filter A16 , it is first necessary to remove the grille A17 at the rear of the vacuum cleaner. Then it is possible to remove the HEPA filter A16 . In the case of light soiling, tap it out. In the event of heavy soiling, wash it under a weak current of running lukewarm water so that the water washes the dirt out of the folds. Allow the HEPA filter A16 to dry naturally, then reinsert it and secure it in place with the grille A17 . It is recommended to replace the HEPA filter with a new one after 6 months of use.
Inflow micro-filter
■ In order to clean and replace the inflow micro-filter A18 , it is necessary to first remove the dust container A7 out of the vacuum cleaner. Hold the dust container with one hand and with the other hand turn the handle A2 in the direction of the open padlock symbol that is marked on the dust container A7 . Take the inflow micro-filter A18 out of the dust container A7 . Tap out its contents or wash it under a weak current of running lukewarm water and allow it to dry naturally. Then insert it back in its place. In the event of heavy soiling or wear and tear, replace the used micro-filter A18 with a new one.
Motor filter
■ Remove the dust container A7 from the vacuum cleaner. If the motor filter A21 is visibility soiled, tap it out or wash it under lukewarm running water and allow it to dry naturally. Install the motor filter A21 and dust container A7 back into the vacuum cleaner. In the event that the motor filter
A21 is showing signs of wear or it is heavily soiled, replace it with a new one.
Note:
For hygiene reasons, we recommend that you tap out the filters away from living areas.
Copyright © 2019, Fast ČR, a.s.
- 7 11/2019
Attention:
Before putting the filters back into the vacuum cleaner, make sure that they are completely dry.
Cleaning the flexible hose, telescopic tube, floor nozzle, crevice nozzle, and long crevice nozzle
■ If the accessories are soiled, take them out and clean away all dirt (dust, hair, animal fur, etc.).
Cleaning the outer surface of the vacuum cleaner
■ Clean the outer surface using a dry or a lightly dampened cloth. Then wipe it thoroughly dry.
■ For cleaning the vacuum cleaner, do not use steel wool, abrasive cleaning products, solvents etc.
TECHNICAL SPECIFICATIONS
Rated voltage range ...................................................................................................... 220 – 240 V~
Rated frequency ................................................................................................................... 50 / 60 Hz
Rated power input ...................................................................................................................... 700 W
Noise level .................................................................................................................................. 78 dB(A)
Dust container capacity ................................................................................................................. 3.5 l
HEPA filter efficiency class ............................................................................................................... 13
Length of the power cord ............................................................................................................. 7 m
Operational radius ........................................................................................................................ 10 m
Dimensions (length× width× height) ............................................................460x275x330 mm
Weight. .............................................................................................................................................. 4.9 kg
The declared noise emission level of the appliance is 78 dB(A), which represents a level
A of acoustic power with respect to a reference acoustic power of 1 pW.
Safety class for electrical shock protection:
Class II – Electrical shock protection is provided by double or heavy-duty insulation.
We reserve the right to change text and technical specifications.
INSTRUCTIONS AND INFORMATION REGARDING THE
DISPOSAL OF USED PACKAGING MATERIALS
Dispose of used packaging material at a site designated for waste in your municipality.
DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT
This symbol on products or original documents means that used electric or electronic products must not be added to ordinary municipal waste. For proper disposal, renewal and recycling hand over these appliances to determined collection points. Alternatively, in some European Union states or other European countries you may return your appliances to the local retailer when buying an equivalent new appliance. Correct disposal of this product helps save valuable natural resources and prevents potential negative effects on the environment and human health, which could result from improper waste disposal. Ask your local authorities or collection facility for more details. In accordance with national regulations penalties may be imposed for the incorrect disposal of this type of waste.
For business entities in European Union states
If you want to dispose of electric or electronic appliances, ask your retailer or supplier for the necessary information.
Disposal in other countries outside the European Union.
This symbol is valid in the European Union. If you wish to dispose of this product, request the necessary information about the correct disposal method from the local council or from your retailer.
This product meets all the basic requirements of EU directives related to it.
Copyright © 2019, Fast ČR, a.s.
- 8 11/2019
