Hasbro Claw Vehicle 1991 Instructions

 N
Л ~ OPERATION
5
First locate the power switch on the lower rear = =
portion of the vehicle, When the lever is moved to = of
the right or “OFF” position (as shown in A) the /
A {7X
nt —
motor is turned off. This permits the wheels to nn ir 7 ——— В
move freely, allowing THE CLAW™ Vehicle to roll on Al AL an |
both forward and backward. | |
———
mms Fees et Pm cn es fash анал но он оной
= Е
When lever is moved to the left or “ON” position (1 Em FE
(as shown in B] the vehicle will move under its
own power, ready to travel and climb any rough
terrain.
00 €
AN
E]
=
Fy AN ——— =
While operating your vehicle on a smooth surface, Once your vehicle comes upon rough terrain, the
the wheels roll normally. wheels open when they meet resistance to expose
the claw-like teeth inside. THE CLAW™ Vehicle is a
savage, untamed monster truck!
WHEEL CLEANING
If the vehicle's wheels need cleaning or become
jammed, turn the power switch off and pull the
wheel open.
—
a
BB a
Ч S
u SS
LABEL \ >“
PLACEMENT
Apply labels by following numbers on label sheet and
using these illustrations as a guide.
After applying labels to lights, snap lights to roll bar
as shown below.
=
ONE-TIME
ASSEMBLY
EM
Once assembled
innot be taken apart!
3 E
GE
—
Back
BATTERY
INSTALLATION
me
т
lever
closed
1. Locate battery compartment on front portion of
truck. Rotate lever down to unlock the battery
compartment door, and remove door to view the
battery compartment.
2. Use four “C” alkaline batteries (batteries not
included). Install the batteries on left side of battery
compartment with the positive (+) end out, and the
right side positive (+) end in as shown.
3. To replace the compartment door, insert the {ар с.
left side of compartment door into slot on chassis
and swing door to closed position.
4. Shut and lock door by rotating lever as shown.
a
©1991 Kenner Products #6657004000