Andrews ASF 950 Owner Manual

ASF 950

Fan

Operating Instructions

& Safety Guide

0800 211 611 andrews-sykes.com

General Safety

Electric Ventilation Fans are for internal use only.

This equipment should only be used by a competent person

Getting started and operation

Position equipment on level ground

Fig 1

Check condition of equipment before use. If unit is showing any signs of damage contact your supplier immediately.

.

Never operate this equipment if you are ill, feeling tired or under the influence of alcohol or drugs.

Do not use in wet or damp conditions.

Keep all vents and grilles clear of obstructions.

Keep children and animals away from electric appliances.

Fig 1

Never leave them alone in room where the units in use.

Make sure equipment is switched off and unplugged after use.

1. Connect to electrical supply

Fig 2

2. Switch on power and set rocker switch to

Electrical Safety

position 1

230 volt units require a standard domestic 13 amp socket.

Always inspect plugs and power cables for damage before plugging into power supply.

DO NOT USE IF ANY DAMAGE IS FOUND.

Ensure cables are installed so as not to cause a hazard.

If an extension lead is used, ensure it is of the correct standard and fully uncoiled before use.

Cables must not be laid in wet or damp areas.

Do not move equipment while operating.

Do not pull equipment by the power lead.

Fig 3

3. Select required fan speed (Variable speed versions only)

4. Switch off power and unplug unit when finished with.

It is recommended that the electrical supply to this equipment is protected by an RCD.

CAUTION Ear defenders should be worn when fan is running at full speed. Max 85dba @ 1mt.