Evolveo WR153ND wifi network Quick Start Guide

Q u ic k i i in s st al ll la t ti io n g ui id

1.

Getting started

ABACUS Electric Ltd. hereby declares the EVOLVEO WR153ND is in compliance with the essential requirements of the 1999/5/EC (Order no.426/2000 Coll.) directive. For the complete text of the declaration of conformity, please visit ftp://ftp.evolveo.eu/ce .

The 11N WR153ND wireless broadband router is delivered with the following factory default parameters of the Ethernet LAN interfaces.

Default IP Address: 192.168.1.1

Default subnet mask: 255.255.255.0

WEB utility User Name: admin

WEB utility Password: admin

The device features three operation modes (Bridge/Gateway/WISP). The default IP addresses for the device are 192.168.1.1 so please make sure the IP address of your PC is in the same subnet as the router - e.g.

192.168.1.x.

It takes about 25 seconds to complete the booting after power on.

Prepare your PC to configure the 11N wireless Broadband router

For the Microsoft Windows XP/ win7/ LIUNX /MAC OS

1.

Click the Start button and select Settings. Then click the Control Panel . The Control Panel window will appear.

2.

Move the mouse and double-click the Network icon. The Network window will appear.

3.

Check the list of the installed network components. If TCP/IP is not installed, click the Add button to install it; otherwise continue to the step 6.

4.

Select Protocol in the Network Component Type dialog box and click the Add button.

5.

Select TCP/IP in the Select Network Protocol dialog box then click OK to install the TCP/IP protocol - you may need the Windows install CD to complete the installation. Close the window and go back to

Network dialog box after the TCP/IP installation.

6.

Select TCP/IP and click the Properties button in the Network dialog box.

7.

Select Specify an IP address and enter the values as the following example.

IP Address: 192.168.1.1, (any IP address within 192.168.1.2 - 192.168.1.254 is suitable for the Wireless

LAN Access Point connection).

IP Subnet Mask: 255.255.255.0

2.

Web Utility Configuration

Connect to the router by entering

http://192.168.1.1

in the address field of your web browser.

A login window, similar to that one in the Figure, will appear in a moment. Enter admin for the User

Name and enter admin for the Password, both in lower case letters. Then click OK or the Login button.

Then you will see