Roche URISYS 1100 Quick Reference Guide
Add to My manuals1 Pages
Roche URISYS 1100: The URISYS 1100 Urine Analyzer provides accurate and reliable urinalysis results, making it an ideal choice for healthcare professionals. It features simple operation, a user-friendly interface, and automatic calibration for ease of use. The device can read Chemstrip 10 MD* Test Strips, commonly used for urinalysis in hospitals and clinics. With its compact design and portability, the URISYS 1100 is suitable for various settings, including point-of-care testing and physician's offices.
advertisement
Urisys 1100
®
Urine Analyzer – Setup Instruction Sheet
For complete details regarding installation, please see Section 4 of Operator’s Manual.
1) Unpacking
Carefully remove the contents of the Urisys 1100 ® Urine Analyzer box and check for the following items: a) Urisys 1100 ® Urine Analyzer b) AC adapter c) Power cord d) Roll of printer paper e) Test strip tray, Type C, for reading Chemstrip ® 10 MD* Test Strips
a
d
e
b
c Items included, but not pictured.
• Operator’s Manual (including Policies and Procedures CD)
• User Training CD
• Quick Reference Guide
• Warranty Card
Please note: Chemstrip urine test strips and Chemstrip
Calibration Strips are not included and must be purchased separately.
2) Setup
Place analyzer on level surface.
Connect AC adapter to power cord and then to power socket at rear of analyzer. Plug power cord into power outlet.
3) Insert Strip Tray
Select appropriate test strip tray. (Use Type C to read
Chemstrip 10 MD* Test Strips. ) Hold strip tray with gray reference pad facing up. Slide test strip tray into slot below function keys until retaining bar closes.
4) Install Paper
Release printer cover by pressing area immediately below and to right of printer paper slot. Lift cover and place printer paper roll into compartment as shown below. Pull paper forward over the edge of paper slot. Close cover.
5) Self Check
Switch on Urisys 1100 ® Urine
Analyzer using on/off switch at rear of analyzer. The analyzer automatically performs a self check. If self check is completed successfully, the message “SELF
CHECK OK” prints along with time and date.
6) Calibrate
Before using the analyzer, it must be calibrated using Chemstrip Calibration
Strips (Cat. No. 11379194160). After the self check, the message “REPEAT
CALIBRATION” appears on the display.
Press the blue START button and the message “START CALIBRATION” displays.
Place a calibration strip, with the pads facing upward, on test strip tray. (The leading edge of strip should be held by the clip at end of test strip tray. The retaining bar must be open.) Press START button.
The display will then read, “Heat up! Please wait, xx sec left.” Once the countdown finishes, the measurement begins. If calibration results are acceptable, the message “CALIBRATION O.K.” displays and results are printed.
7) Begin Testing
The Urisys 1100 ® Analyzer is ready to begin reading test strips when the message “INSERT STRIP” is displayed.
Customer Support
If you need assistance, contact
Roche Diagnostics Customer
Support Center at 1-800-428-4674,
7 days a week, 24 hours a day, and
365 days per year.
* Hospitals may use Chemstrip ® 10 UA Urine Test Strips.
COBAS, LIFE NEEDS ANSWERS, URISYS 1100 and CHEMSTRIP are trademarks of Roche.
© 2012-2018 Roche Diagnostics. All rights reserved.
Rx Only
VV-06557-02 https://usdiagnostics.roche.com
03755550001(07) 2018-09 USA
advertisement
Related manuals
advertisement