Anti-Theft Device
Assembly, Installation and Operating Instructions
Model Nos. 1614 and 1714
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage before using. In case of damage, do NOT use. Contact the
Dealer/Carrier for further instructions.
SAFETY SUMMARY
The following recommendations are made for the installation of the anti-theft device:
GENERAL WARNING
DO NOT install or use this equipment without first reading and understanding these instructions. If you are unable to understand the Warnings, Cautions or Instructions, contact a healthcare professional, dealer or technical personnel before attempting to install this equipment - otherwise, injury or damage may occur.
Anti-Theft Tube
Locknuts
Half-Clamp
Dimple
Hole
DETAIL"A"
Back Cane
Armrest
Half-Clamp
Carriage
Bolts
Skirt Guard
This kit contains the following:
DESCRIPTION
Anti-Theft Tube
Half-Clamps
Carriage Bolts
Locknuts
Instruction Sheet
QTY
2
2
1
2
1
TRACER 4
NOTE: Position bend
In anti-theft tube towardsinside of wheelchair.
Back
Upholstery
INSTALLING THE ANTI-THEFT
DEVICE (FIGURE 1)
1. Loosen, but DO NOT remove the two (2) lower
(Tracer Fixed Front) or the two (2) upper (Tracer 4) phillips screws that secure the back upholstery to the back canes shown in FIGURE 1.
2. Position the half-clamps on the back cane as shown in DETAIL "A".
3. Make sure of the following:
A. The dimple in each of the half-clamps is towards the outside of the wheelchair.
B. The half-clamp positioned behind the back cane is between the back upholstery and the back cane.
C. The half-clamps are positioned between the top of the skirt guard and the bottom of the armrests for the TRACER FIXED FRONT.
D. The half-clamps are positioned above the armrest for the TRACER 4.
Phillips
Screws
NOTE: Position bend in anti-theft tube towards inside of wheelchair.
Phillips
Screws
Back Upholstery
TRACER FIXED
FRONT
FIGURE 1 - INSTALLING THE ANTI-THEFT DEVICE
1
4. Install the carriage bolts that secure the half-clamps together and loosely secure with the locknuts provided.
5. Position the anti-theft tube between the half-clamps as shown in DETAIL "A" in FIGURE 1.
WARNING
Make sure the holes in the anti-theft tube line up with the dimples in the half-clamps.
If the holes and dimples DO NOT line up, injury or damage can occur.
USING THE ANTI-THEFT DEVICE
(FIGURE 2)
WARNING
NEVER maneuver an occupied wheelchair by using ANY part of the anti-theft device.
Serious injury or damage can occur. ALWAYS use the handles of the wheelchair when maneuvering an occupied wheelchair.
6. Line up the holes in the anti-theft tube and the dimples in the half-clamps.
CAUTION
DO NOT overtighten attaching hardware.
Damage to anti-theft tube can occur.
7. Tighten the carriage bolts and locknuts. DO NOT overtighten.
NEVER Use any part of this anti-theft tube to
Manuever an Occupied
Wheelchair.
Invacare Corporation
USA
ALWAYS Use the handles of the wheelchair to Manuever an Occupied
Wheelchair.
FIGURE 2 - USING THE ANTI-THEFT DEVICE
Invacare and "Yes, you can" are trademarks of Invacare
Corporation.
© 2000 Invacare Corporation
Form No. 97-147 Part No. 1075583 Rev B (1) 7/00
