OPERATIONS MANUAL

Pro Cut-Off Gauge

Make Cuts Faster Without Measuring Each Cut

®

STEP 2

To set up for first-time use, measure back from the edge near each end of the workpiece and make a mark. Flip the Cut-Off Gauges down. The ends of the Cut-Off Gauges indicate where the Cut-Off will make the cut. Move the workpiece until the marks align with the ends of the gauges, then lock the brake.

Attach Pro Cut-Off Gauge

STEP 1

Position the work piece in the Brake and close the Brake to loosely hold the material. Attach a Cut-Off Gauge near each end of the material.

Do this by placing the clip opening against the back edge of the Locking Anvil and pulling it sharply forward until it locks in place. Make sure the clip is as far forward as it can go. Flip the Cut-Off Gauges up and out of the way.

CUT LINE

WWW.TAPCO-EUROPE-TOOLS.COM

PRO CUT OFF GAUGE INSTRUCTIONS

STEP 3

Flip the Gauges up and out of the way of the Cut-Off and make the cut. Look at the cut relative to your marks. Due to variations in Cut-Offs, it may be necessary to adjust your future marks to compensate for any differences.

STEP 4

When working with shorter lengths of material, the Gauge can be repositioned by sliding it along the

Anvil. It can be removed by pulling down on the bottom of the clip and sliding it off. Another way is to simply push sideways on the end of the Gauge to force the Clip off the Anvil.

The raised tab on the Gauge makes a convenient place to hook a Tape

Measure for layout. The tab is positioned to match the nose of the Anvil or the bend point of the workpiece.

©2014 Tapco International Corporation

Tapco Integrated Tools Systems

Unit 32, Tokenspire Business Park, Hull Road, Woodmansey, Beverley, East Yorkshire, HU17 0TB

Item #12308