Kodak 8461444 - Max Flash Camera One Time Use Setup Manual
Advertisement
Advertisement
CIS-256
June 2004
CURRENT INFORMATION SUMMARY
Opening Instructions for the
KODAK Zoom One-Time-Use Camera
Wear eye protection when opening all cameras.
1
Wind Off
0 shutter button thumbwheel
2
Insert Tool
• Make sure “0” is aligned with the arrow in the
frame-counter window.
• If the “0” is not aligned, grip the camera and
cover the lens.Then press the shutter button
and turn the thumbwheel (repeat these steps
until the film is fully rewound).
The film is fully rewound when the thumb-
wheel rotates freely and does not stop or lock.
Break Off Film Door
3
• Insert the special tool into the end slot.
4
Remove Film
• Using the special tool, hold the camera firmly
and pull upwards to break off the film door
and to remove the film.
5
• Place the used camera in the
Kodak recycle bin.
• Visit our Web site at http:// www.kodak.com/go/kes for details about Kodak’s recycling program.
• Call Kodak’s advertising distribution center at (800) 847-8755 to order a Kodak hand-opening tool.
Opened camera with film removed.
Exposed
Film
CAUTION: Before you attempt the opening tasks, make sure the tool is fully engaged with the camera body to prevent tool slippage.
CAUTION: This camera body contains a high-voltage capacitor and circuit board. To avoid electric shock, do not pry apart the front and back sections of the camera. Remove only the film from its respective compartment. If sections of the camera are separated, do not touch the circuit board.
© Eastman Kodak Company, 2004
Current Information Summaries provide information of limited or specific application. Responsibility for judging the timeliness and applicability of the information to a specific photographic use rests with the end user.
Consumer Imaging
EASTMAN KODAK COMPANY • ROCHESTER, NY 14650
CIS-256, Opening Instructions for the
KODAK Zoom One-Time-Use Camera Kodak is a trademark.
New 6-04
Download
Advertisement