Quick Installation Guide
LongView
®
Wireless Extender
The following instructions will allow you to connect your LongView Wireless extender.
Should you require assistance, please consult your installer/user guide.
To connect a LongView Wireless extender
Transmitter Receiver
Connect the transmitter cable into the appropriate ports on the computer.
Connect the audio.
4
Connect to an
AC power source.
7
Connect to an
AC power source.
6
Connect the extended speaker.
Connect the local user’s keyboard, monitor and mouse.
5
Connect the extended user’s keyboard, monitor and mouse.
Connecting the peripherals to the transmitter
Power down the computer that will be part of your LongView
Wireless system and unplug its peripherals. Place the transmitter near the computer and connect the LongView
Wireless transmitter cables into the computer’s PS/2 keyboard, PS/2 mouse and monitor connections.
Connecting the audio to the transmitter
Using the supplied audio cable, connect one end to the transmitter’s audio input connection and the other end to the computer’s audio output connection.
Connecting a local user to the transmitter
Connect the local user’s keyboard, monitor and mouse into the appropriately marked ports on the rear of the transmitter.
Powering up the transmitter and computer
Connect your transmitter to an AC power source with one of the included power supplies and power up your computer.
NOTE: Use only an Avocent-supplied power supply. The transmitter must be powered up before the computer.
Powering up the receiver
Connect your receiver to an AC power source with one of the included power supplies and power up your computer.
Once you power up the receiver, a screen will display the message Searching for CLT-XXX, OSD Closed, Waiting on
Video.
Within a few seconds, the screen will go blank. A new screen will display with your desktop image.
Connecting the peripherals to the receiver
Connect the extended user’s keyboard, monitor and mouse into the appropriately marked ports on the rear of the receiver.
Connecting the audio to the receiver
Connect your PC speakers into the receiver’s audio output connection.
For additional information
For further instructions on LongView Wireless extender connection, please refer to the installer/user guide included with the extender to activate the OSD (On-
Screen Display) and run the Auto Setup feature.
To Contact Avocent Technical Support CALL (888) 793-8763 EMAIL [email protected]
Avocent, the Avocent logo, The Power of Being There and LongView are registered trademarks of Avocent Corporation or its affiliates. All other marks are the property of their respective owners. ©2004 Avocent Corporation. All rights reserved.
DOWNLOAD www.avocent.com
590-385-001B
Quick Installation Guide
LongView
®
Wireless Extender
Notifications and Approvals
USA Notification This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including received interference that may cause undesired operation.
Agency Approvals
UL, cUL, FCC
To Contact Avocent Technical Support CALL (888) 793-8763 EMAIL [email protected]
Avocent, the Avocent logo, The Power of Being There and LongView are registered trademarks of Avocent Corporation or its affiliates. All other marks are the property of their respective owners. ©2004 Avocent Corporation. All rights reserved.
DOWNLOAD www.avocent.com
590-385-001B
