Chloride MSL Series Mini LED Step Light Install instructions

CHLORIDE
by G)ignify
Step Lights
MSL Series — Mini Step Light
INSTALLATION INSTRUCTIONS
LED MINI STEP LIGHT
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
When using electrical, basic safety precautions should
always be followed including the following.
1, Disconnect power at fuse or clrcult breaker before Installlng
or servicing.
2, Do not mount In hazardous locations, or near gas or electric
heaters.
Do not let power cords touch hot surface,
4, Equlpment should be mounted In locatlons and at helghts
where It will not be subjected to tampering by unauthorized
personnel,
5, The use of accessory equipment not recommend by the
manufacturer may cause an unsafe condltlon.
6, Do not use this equipment for other than intended use,
7. Allservicing should be performed by a quallfled personnel only.
8, All electrical connection must be in a accordance with local codes,
ordinances, and the Natlonal Electric Code, If you are unfamiliar
with methods of Installing electrical wiring, secure the services of
@ qualified licensed electrician.
SAVE THESE INSTRUCTIONS
<>
Mounting Instructions
1, Unscrew face plate screws by screwdriver then remove
face plate(see Fig 1),
2, Connect the fixture wires to J-box wires from building using
wire nuts, connect the white wire to neutral, connect the black
wire to hot wire(120VAC), connect green wire to ground wire
(see Flg 2).
3, Install fixture on J-box by 2 bracket screws provided (see Fig 3),
4. Place face plate on fixture, put 2pcs washer provided on
screw then fixed face plate by 2 screws (see Flg 4),
5, Restore power at circuit breaker or fuse,
6, Finish installation.
6/4/2020 page 1 www.chloride-lighting.com
120VAC Input
À
Fig 1
——_Расе Ре
Screws for
Face Plate
_— box
—
ms
— о
Black wire
(120МАС)
White whe
(Neutral)
Green wire
(ground)
Fig 4
IS-7733490A Step Light — MSL Series
Face Plate Styles
m |
e
Vertical Horizontal
louver face louver face
How To Change Face Plate Direction
If need change face plate direction, please according below instruction,
These instruction also for photocell model.
1. Remove original vertical face plate.
2. Unscrew 2pcs bracket screws,
3. Adjust bracket 90 degree and assemble it on plastic case again,
please noted use another 2 screw holes on bracket.
4, Use horizontal face plate instead of vertical face plate.
Vertical Face Plate
Horizontal Face Plate
© 2019 Signify Holding. All rignts reserved. This document may be subject to change. Signify North America Corporation Signify Canada Ltd.
No representation or warranty as to the accuracy or completeness of the information 200 Franklin Square Drive, 281 Hillmount Road,
included herein is given and any liability for any action in reliance thereon is disclaimed. Somerset, NJ 08873 Markham, ON, Canada L6C 253
All trademarks are owned by Signify Holding or their respective owners. Telephone 855-486-2216 Telephone 800-668-9008
6/4/2020 page 2 www.chloride-lighting.com