AS5601-SO_EK_ST
Evaluation Kit
Quickstart Guide
Step 1: Kit Content
This kit contains following material listed in the table below. Additional information about material can be found on our webpage.
No. Item Info
1 USB I&P Box Programming and Interface
Box (Includes USB Drive,
USB Cable, 10way cable,
USB I&P Box)
2 AS5601-
SO_EK_AB
Adapterboard including reference magnet
3 RMH05-DK-
XX-1.0
Rotary Magnet Holder with
Knob
Step 2: Install the AS560X Demo Software
The Software is located on the USB drive that comes with the USB I&P Box or it can be downloaded from our webpage. After Installation run the software.
2
Step3: Assemble the Hardware Setup
B.
C.
Step4: Using the software
Following steps are required to perform a configuration and to read-out the AS5601. Read the software user manual for details.
A. Perform the desired configuration
Perform the required angle programming.
Verify the results
3
Support
Download the latest manual from the product webpage: http://www.ams.com/eng/Support/Demoboards/Position-Sensors/Rotary-
Magnetic-Position-Sensors/AS5601-Eval-Kit
Note:
This Programmer is for LAB Evaluation only.
Do not use it as a Production Programmer!
Contact Information
Headquarters ams AG
Tobelbader Strasse 30
8141 Unterpremstaetten
Austria
T. +43 (0) 3136 500 0
For Sales Offices, Distributors and Representatives, please visit: http://www.ams.com/contact
4
