RUE-4202

Remote Control Unit

Owner's Manual

Controls on Remote Control

CD Source Button

Press to select the audio source.

Volume Adjustment Buttons

To increase the volume level:

Press the

0 button

To decrease the volume level:

Press the

G button

... Button

Radio mode: Pressing the button will select, in ascending order, stations programed into the radio's presets as shown below.

rITJ~rn

...

rn~

®

®

CD Changer mode: DISC Select (UP) Button

Press the button to select a disc in ascending order.

MP3IWMA mode: Folder Select (UP) button. Press this button to select the folder.

MP3 compatible CD changer mode (while playing back

MP3):

Folder Select (UP) / DISC Select (UP) button

Press this button to select a folder in ascending order.

Press and hold this button to select a disc in ascending order.

Tape mode: Pressing this button enters the Program

Sensor Up mode.This allows for music selection towards the end of the tape.

Audio Processor Mode: Press this button to adjust the

MODE that is called by pressing the A.PROC. button.

~ Button

Radio mode: SEEK (ON) Button

CD/CD changer mode: Press the button to go back to the beginning of the current track.

Tape mode: REW Button

~/Il Button

Press the button to switch between the Play and Pause modes for CD or MD and Tape.

Audio Processor Button

Each press of the button changes the audio processor mode.

Press ... or'" button to perform setting / adjustment.

Press the button to call the external audio processor mode when the external audio processor is connected."

.,

For the operation of external audio processor, refer to the Owner's

Manual of the external audio processor you purchased.

(J) Power Button

®

Press the button to turn the power on/off.

Band Button

Radio mode: BAND Button

Changer mode: BAND Button

Switches changers (when a MUlti-Changer SWitching

® device is connected).

Tape mode:

Press the button to change between the A and B side of the tape.

~ Button

Radio mode: SEEK (UP) Button

CD/CD changer mode: Press the button to advance to the beginning of the next track.

Tape mode: FF Button

... Button

Radio mode: Pressing the button will select, in descending order, stations programed into the radio's presets as shown below.

r[§J~[ID·

..

ITJ

~

@

CD Changer mode: DISC Select (ON) Button

Press the button to select a disc in descending order.

MP3IWMA mode: Press the Folder Select (ON) button.

Press this button to select the folder.

MP3 compatible CD changer mode (while playing back

MP3):

Folder Select (ON) / DISC Select (ON) button

Press this button to select a folder in descending order.

Press and hold this button to select a disc in descending order.

Tape mode: Pressing this button enters the Program

Sensor Down mode.This allows for music selection towards the beginning of the tape.

Audio Processor Mode: Press this button to adjust the

MODE that is called by pressing the A.PROC. button.

Mute Button

• Press the button to lower the volume by 20 dB instantly. Press the button again to cancel.

• Press the button for at least 2 seconds to raise the monitor. Press the button again to lower the monitor.

(Head unit with Monitor Display, etc.)

Depending on the device you are using, you cannot operate or may need to operate differently some devices on the remote control.

For details, refer to the Owner's Manual ofthe device you purchased.

Handling Precautions

Do not drop or apply shoCk to the unit. It may be get permanently damaged.

Keep the unit away from water and moisture, direct sun and heat, and excessive dust.

Never use scouring pads, steel wool, abrasive powders or harsh chemical agents, such as lye solution, for cleaning.

Clean with a soft, lint-free cloth or cotton swab slightly dampened with a mild solution of detergent and water.

Do not operate this unit in a manner that could distract you from driving safety.

Battery Replacement

Applicable battery: Use two "AAA" sized dry batteries or equivalent.

1

Opening the battery cover.

Slide out the battery cover while firmly pressing the direction of arrow.

2

Replacing the battery.

Put the batteries in the case observing the polarities as illustrated.

3

Closing the cover.

Push the cover as illustrated until a click is heard.

In Case of Difficulty

Problem

Remove

Cause

Reverse

Control placement of

Inoperative.

battery.

Dead battery.

Solution

Place the battery correctry into its cradle in the compartment.

Replace the battery with a new one.

Remote Control not Point the remote control pointed toward the directly toward your head unit.

head unit.

Specifications

Battery Type

Battery Quantity

Dimensions(W x H x D)

Weight (without battery)

Accessory

AAA sized dry batteries

2

42 x 121 x 22mm

(1-21/32" x 4-25/32" x 7/8")

50g (1.8 oz)

Remote Control Unit Holder

ALPINE ELECTRONICS MARKETING, INC.

1-1-8 Nishi Gotanda,

Shinagawa-ku,

Tokyo 141-0031, Japan

Phone 03-5496-8231

ALPINE ELECTRONICS OF AMERICA, INC.

19145 Gramercy Place, Torrance,

California 90501, U.S.A.

Phone 1-800-ALPINE-1 (1-800-257-4631)

ALPINE ELECTRONICS OF CANADA, INC.

777 Supertest Road, Toronto,

Ontario M3J 2M9, Canada

Phone 1-800-ALPINE-1 (1-800-257-4631)

DONGGUAN GAOQI PRINTING CO., LTD.

YANG WU NO.2 IND. DISTRICT DALING SHAN TOWN

DONG GUAN CITY GUANG DONG CHINA

ALPINE ELECTRONICS OF AUSTRALIA PTY. LTD.

161-165 Princes Highway, Hallam

Victoria 3803, Australia

Phone 03-8787-1200

ALPINE ELECTRONICS GmbH

Frankfurter Ring 117,

80807 MOnchen, Germany

Phone 089-32 42 640

ALPINE ELECTRONICS OF U.K. LTD.

Alpine House

Fletchamstead Highway, Coventry CV4 9TW,

U.K.

Phone 0870·33 33 763

ALPINE ELECTRONICS FRANCE S.A.R.L.

(RCS PONTOISE B 338101 280)

98, Rue de la Belle Etoile, Z.1. Paris Nord II,

B.P. 50016, 95945 Roissy Charles de Gaulle

Cedex, France

Phone 01-48638989

ALPINE ITALIA S.p.A.

ViaJe C. Colombo 8, 20090 Trezzano

Sui Naviglio (MI), Italy

Phone 02-484781

ALPINE ELECTRONICS DE ESPANA, SA

Portal de Gamarra 36, Pabel16n, 32

01013 Vitoria (Alava)-APDO 133, Spain

Phone 945-283588

68-04123Z30-A

Printed in China(Y)