AcousticSheep SleepPhones Instruction Manual

Instruction Guide for SleepPhones® Classic

1

How to Wear your SleepPhones®

2

1. Holding the SleepPhones® in your hands, you’ll notice the flat speakers - one on each side - inside of the headband.

2. Place the headband on your head. Note that the

SleepPhones® logo tag goes at the back of your head. The cord comes out the hook & loop opening at the back of the headband.

3

3. Once the headband is on, you’ll want to adjust the speakers so that they are positioned directly over your ears. This will ensure great sound quality. Please note that the speakers move inside of the headband, independently of the headband.

1 2

Removing the Speakers

3

1. There is a hook & loop opening at the back of the headband. Open to reveal the speaker components inside the headband.

2. Pull very gently on the speakers, one at a time, to remove them from the headband.

3. Once the speakers are removed, you can machine-wash the headband.

1 2

Reinserting the Speakers

3

1. The right speaker will have red stitching. The left speaker will have green stitching. The softer gray

(fleece) side should be facing in towards the ear and the coarse (felt) side should face away from the ear.

2. Insert the speakers, one at a time, about four inches from the hook & loop opening on both sides of the headband.

3. Then insert the junction pad into the headband and close the hook & loop opening.

Speakers

Check out the instructional video!