FLIR identiFINDER R200 Quick Start Manual

TURN IDENTIFINDER R200 OFF

Press and hold Power button until prompted for confirmation.

Select to confirm power off.

KIT CONTENTS

In addition to the identiFINDER R200 instrument, the kit

( P/N 4204085 ) includes the following items:

P/N DESCRIPTION

4204026 Power Supply; includes US, UK, EU and AU Adaptors

4204015 USB Cable 2.0; type A to mini-B male; 2.0 meters

102001 Wrist Strap Lanyard; 24 inches; black

4203626 Holster

4204014 USB Flash Drive

• Quick Start Guide PDF

• Operations manual PDF

• Software Drivers Installer

NEED MORE INFO?

1 Read Operations Manual (PDF): located on USB drive.

2

Access Online Resources: Go to https://flir.pw/r200

Equipment described herein may require US

Government authorization for export purposes.

Diversion contrary to US law is prohibited.

©2016 FLIR Systems, Inc. All rights reserved.

02232016

4.6x6.1_R200_QSG_022216.indd 2-3

LED Indicator

Green = Power On

OVERVIEW

identiFINDER R200 SPRD

Display and Navigation Buttons

Navigation Buttons correspond to command icons on Display Taskbar

Center of

Detection

Display

Taskbar

Left

Power

CHARGE BATTERY

and replace backup battery

Flip down port cover and insert charging cable.

Right

LED Indicator

Red = Alarm

Center

Speaker

Connection Port

(For Charging & Communication)

Display indicates percent charged

Replace Backup Battery

Rotate counter-clockwise to remove

Backup Battery Door. Remove old CR123A battery and insert new one. Rotate battery door clockwise until fully sealed.

2/24/16 4:57 PM

TURN IDENTIFINDER R200 ON FINDER MODE

In Finder Mode, the instrument can be used to localize the source of an elevated dose level. If Finder Mode is not needed, skip to Identification Mode by pressing:

Press & hold

Power button until splash screen appears

FLIR splash screen Wait until instrument completes initialization

(<30 seconds)

Dose Rate Mode (Home) appears automatically following initialization

You are now actively operating the unit as a Personal Radiation Detector.

DOSE RATE MODE

(Default Mode)

Dose Rate Mode

(Home)

In Dose Rate Mode, the instrument is measuring the gamma dose rate and will automatically alert the operator when there is a significant change in ambient dose rate level or when an alarm threshold is breached.

Radiation Detected

(Alarm)

Current Dose Rate

(Analog)

Dose Rate Reading and Units (Digital)

May also be displayed in Sieverts

https://flir.pw/r200

Mute Alarm

Acknowledge Alarm

After alarm, proceed to Finder

Mode or Identification Mode.

4.6x6.1_R200_QSG_022216.indd 4-5

Press to enter Finder Mode.

Wait while background baseline is established

(10 seconds). The R200 will then automatically enter Finder Mode. Bars indicate increased or decreased activity levels during search.

Once source is located, press to identify source.

Proceed to Identification Mode.

IDENTIFICATION MODE

In this mode, the R200 collects data & analyzes it to determine the identification of the source nuclide(s).

Once source is detected or located, press to enter

Identification Mode.

The Magic Eye and on-screen prompts will guide you to maintain optimum distance from source. Screen shows % complete or time remaining for data collection. Instrument automatically analyzes data when collection is complete.

Press to display the spectrum.

To exit the identification mode and return home press .

2/24/16 4:57 PM