advertisement
ONErack
patent pending
Installation Guide
Chassis
MNL-1RK-CHASSIS v1.10
Tools
Pozidriv® PZ2 crosshead screwdriver
In the box
2 Side panels
(identical)
1
6 Mounting rails
3 M3 bolt strips
24 M4 screws
1 M6 rack mounting kit 4 x 4 x 4 x
In the unlikely event that a component is missing or damaged, please contact [email protected] or [email protected]
ONErack
Building the chassis
To avoid damaging your ONErack, build it in a clean, tidy area.
1.
Use two M4 screws to connect each mounting rail to one side panel.
Make sure each mounting rail is aligned as shown.
2.
Slide an M3 bolt strip into each of three mounting rails, as shown.
*
*
*
*
*
* tvONE 2
3.
Use the remaining 12 M4 screws to connect the other side panel to the mounting rails.
Contact us
www.tvone.com
tvONE NCSA
North, Central and South
America
2791 Circleport Drive,
Erlanger, KY 41018, USA
tvONE EMEA
Europe, Middle East, Africa and
Asia Pacific
Continental Approach,
Westwood Industrial Estate,
Margate, Kent, CT9 4JG, UK
Sales: [email protected]
Support: [email protected]
Sales: [email protected]
Support: [email protected]
Information in this document is subject to change without notice. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or any means electronic or mechanical, including photocopying and recording for any purpose other than the purchaser's personal use without the written permission of tvONE.
Copyright 2016 tvONE. All rights reserved.
3 ONErack
advertisement