GB RD 703
Rinse Hold
PROGRAMME TABLE
1) Programme duration figures (guideline) are valid for maximum temperature wash with no special functions.
Programme Type of fabrics / Degree of soiling / Notes Max.
Load.
Prewash
Detergent and Additives Options
Wash Softener Bleach Intensive
Wash
1/2 Load Rinse
Hold
Maximum
Spin Speed
Recommended
Spin Speed
Programme time approx.
rpm/min rpm/min min 1) kg
Prewash
Cotton 60°C
Coloureds 60°C
Synthetics 40°C
Rinse/Spin
Spin
Delicate 40°C
Wool
Rinse/Spin
Spin
Drain
Heavily soiled sheets, tablecloths, underclothes, shirts etc. in hard wearing and high temperature resistant cotton.
The maximum load for heavily soiled washing is 3.5 kg.
Moderately soiled sheets, tablecloths, underclothes, towels etc. in hard wearing and high temperature resistant cotton.
Averagely soiled textils in cotton, linen, polyester (Diolen, Trevira), polyamide (Perlon, Nylon), other synthetics or similar blends.
Lightly soiled shirts, blouses etc., made of polyester (Diolen,
Trevira), polyamide (Perlon, Nylon) or cotton blends.
This programme allows starch or softener to be added.
It is followed by an intensive spin cycle.
Programme for intensive spin cycle.
Delicate curtains, dresses, skirts and blouses.
Machine washable woollens with pure new wool label.
If the “Rinse Hold” option is selected, don't leave the wash to soak for too long.
This programme allows starch or softener to be added.
It is followed by a gentle spin cycle.
Programme for gentle spin cycle.
Drain only, without spin cycle. Alternative way of terminating programmes after “Rinse Hold” setting
5.0
1.0
1.5
1.5
—
5.0
2.0
2.0
5.0
5.0
1.5
Yes
Yes
—
—
—
—
—
—
—
—
—
Yes
Yes
Yes
Yes
—
—
Yes
Yes
—
—
—
❉
❉
❉
—
❉
❉
❉
❉
❉
—
—
❉
❉
—
—
—
—
—
—
—
—
—
❉
❉
—
—
—
—
—
—
—
—
—
❉
❉
❉
—
—
❉
❉
—
—
—
—
❉
❉
❉
—
❉
❉
❉
❉
❉
—
—
700
700
700
700
700
700
600
600
600
600
—
700
700
450 to 700
450 to 700
450 to 700
450 to 700
100 to 400
100 to 400
100 to 400
100 to 400
—
130
115
100
70
20
10
55
45
15
5
3
N.B.The excess of detergent in the dispenser could cause technical problems.
5019 100 12568
GB
ENERGY AND WATER CONSUMPTION DATA
Programme Load
(kg)
Water
(l)
Energy
(kWh)
Programme duration
(min)
Cotton + Wash Plus 90° C
Cotton 60° C
Coloureds 60° C
Synthetics 40° C
5.0
5.0
2.0
2.5
72
69
66
49
1.8
1.15
0.8
0.5
115
115
100
85
Delicate 40° C 1.5
70 0.65
55
Wool 1.0
70 0.55
45
Programmes with prewash last about 15 minutes more than programmes without prewash. Water and energy consumption values were measured in standard conditions in compliance with the Standard IEC 60456. Individual comsumption may vary in comparison with the values specified in the table, because of differences in supply water pressure and temperature, the load and the type of wash.
ADDING DETERGENT AND ADDITIVES
Pour the detergent and additives into the respective compartments as follows :
• Programme with pre- and main wash
• Main wash programme without prewash
• Fabric softeners and starch
• Bleach
• Stain remover agents
• Anti-scale agents (water hardness 4)
Important :
• Be careful not to fill more than the “MAX” level mark.
• For programme with prewash: do not use liquid detergent.
• For programmes without prewash from cold to 40° C it is recommended to use a liquid detergent to avoid whitish residues on the coloured laundry.
CLOSE THE DOOR AND SELECT THE PROGRAMME
1. Turn the programme selector in the clockwise direction to the desired programme.
2. Turn the spin speed selector to the required speed.
PRESS ANY DESIRED OPTION BUTTON(S)
“Wash Plus” button
• This option will allow you to raise the washing temperature to 95° C instead of 60°C in the “Cotton 60° C” programme.
• Especially recommended for soiled washing.
“1/2 Load”
• Reduces the water consumption in the “Cotton” and “Synthetic” programmes especially during prewash and rinse.
• Recommended for lightly soiled or small washing loads (reduce the quantity of detergent).
“Rinse Hold” button
• The unspun washing remains in the last rinse water, thus enabling creasing and discolouration of the washing to be avoided.
• This option is particularly recommended for the “Synthetics 40°C” or “Delicate 40°C” programmes.
• This option is perfectly suitable if you wish to postpone the spin or you don't wish to spin the washing.
Note: the programme selector stops on “ ”.
Terminate the Rinse Hold option:
• Again press on the “Rinse Hold” button; the programme will terminate automatically with the final spin cycle corresponding to the previously selected wash programme.
• If you don't wish to spin the clothes, switch off the appliance by pressing the “On/Off” button. The warning light goes out. Turn the programme selector to the “Drain” position and switch on the appliance.
PROGRAMME START
Open the water inlet tap and press the “On/Off” button. The warning ligh lights up.
DOOR LOCK
During the running programme the door cannot be opened.
The door locks automatically during all programmes.
If the programme is interrupted or if an electrical power failure occurs, the door unlocks automatically after about 1 minute.
PROGRAMME END
• The programme selector knob is at “Stop”.
1. Press the “On/Off” button. The warning light goes out.
2. Cancel the options by pushing the corresponding buttons.
3. Close the water inlet tap.
4. Wait for the door to unlock (about 1 minute).
5. Open the washing machine door and the drum doors. Remove the washing.
SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER PROGRAMME
START
1. Press the “On/Off” button to switch off the appliance.
The warning light goes out.
2. Select another programme, the spin speed and the options.
3. Press the “On/Off” button to switch on the appliance.
The warning light lights.
TO STOP, RESET A PROGRAMME BEFORE THE END
1. Press the “On/Off” button to switch off the appliance.
The warning light goes out.
2. Set the programme selector to “Drain”.
3. Press the “On/Off” button to start the “Drain” programme.
Only open the door when the programme selector is on “Stop” and the door is unlocked
(after about 1 minute).
5019 100 12568
