GB AWV 708/4
A. Programme Selection Knob
B. Temperature Selection Knob
C. “Spin Speed Selection” Knob
D. “On/Off” Button
“Cold“
A B C D i : option / Yes: dosing required
1)
2)
Do not use liquid detergents.
For improved garment care, spin speed is restricted
to 600 rpm in this programme.
3) For improved garment care, spin speed is null
in this programme.
Max.
Load
Detergents and Additives
Prewash
Main wash
Softener Bleach
Option
Half
Load
Temperature
Max.
Spin
Speed
Programme
Care
Labels
Type of wash / Notes
Cotton with prewash
Synthetics with prewash
Delicate with prewash
Cotton
Cotton short
Mixed Cotton/Synthet.
Synthetics
Delicate
Wool
Silk
Rinse + Gentle
Spin
Rinse + Spin
Spin
Gentle Spin
Drain
–
–
–
–
–
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen,Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Normally to heavily soiled blouses, shirts, overalls etc. made of polyester ( Diolen, Trevira), polyamide (Perlon,
Nylon) or blends with cotton.
Normally soiled overalls ans sportswear made of cotton, polyester, polyamide and blends with cotton.
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
Programme for treating delicate laundry with starch or softener.
Programme for treating cotton or linen laundry with starch or softener.
Programme to spin cotton or linen laundry intensively with maximum spin speed.
Programme to spin delicate laundry gently with a restricted spin speed.
Drain only - no spinning.
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
2,0
4,5
4,5
2,0
–
1,5
1,5
1,0
1,0
4,5
3,0
2,0 kg
4,5 Yes 1) Yes
2,0 Yes 1) Yes
1,5 Yes 1) Yes
–
–
–
Yes
Yes
Yes
–
–
–
–
Yes
Yes
Yes
Yes
–
–
–
–
–
–
–
–
–
– i i i i i i i i
–
–
– i i i i i i i i
– i
–
–
–
–
– i
–
–
– i
–
–
–
–
–
– i
–
–
–
–
–
–
–
–
–
–
–
°C
Max. 90 rpm
700
Max. 60 600 2)
Max. 40 600 2)
Max. 90 700
Max. 60 700
Max. 60 600 2)
Max. 60 600 2)
Max. 40 600 2)
Max. 40 600 2)
Max. 30 – 3)
– 600 2)
700
700
600 2)
–
Ignis is a registered trademark of Whirlpool USA.
5019 512 10042
CONSUMPTION DATA
Temperature
Selector
Load Water Energy Approx. Programme
Duration
Programme
Cotton
Cotton
Cotton
Mixed Cotton/Synthetic
Synthetic
Delicate
Wool
Silk
(°C)
90
60
40
60
40
40
40
30
(kg)
2,0
1,5
1,0
1,0
5,0
5,0
5,0
2,0
(l)
56
60
60
60
63*
53
53
56
(kWh)
1,80
0,95
0,55
0,80
0,40
0,55
0,50
0,30
(hours : minutes)
2:05
2:05
2:05
1:30
1:05
0:45
0:40
0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the
pump drains the water out.
PREPARATION OF WASH CYCLE
1. Load the machine, close the drum doors and check that they are properly locked.
2. Add detergents and additives into the dispenser to no more then the “MAX” level mark, as follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Turn the programme selector knob to the desired programme.
4. Turn the temperature selector knob to the desired temperature.
5. Turn the spin speed selector knob to the desired spin speed. If the spin speed “ ” is selected, the final spin is cancelled, but not the intermediate spins. The programme ends with a drain cycle.
PROGRAMME START
Turn on the tap and press the “On/Off” button .
The indicator light of the “On/Off” button lights up.
Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted.
END OF WASH CYCLE
• The programme selector knob is in the Stop position.
1. Press the “On/Off” button to switch off the machine.
2. Cancel the option.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
5. Open the lid and the drun doors and unload the machine.
SELECT THE DESIRED OPTION
Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet.
“Half Load” button
• Reduces the water consuption in the “Cotton” and “Synthetics” programmes especially during the rinse.
• Especially suitable for lightly soiled or small loads (reduces the quantity of detergent).
• Not suitable for high temperature programmes.
CHANGE THE PROGRAMME DURING THE
WASH CYCLE
1. Switch off machine by pressing the “On/Off” button .
2. Select the new programme.
3. Start programme by pressing the “On/Off” button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the programme for a certain time and continue it later:
1. Press the “On/Off” button .
2. After the desired pause, press again the
“ON/Off” button .
CANCEL PROGRAMME
1. Switch off the machine by pressing the
“On/Off” button .
2. Set the programme selector to “Drain”.
3. Press the “On/Off” button again to start the “Drain” programme .
Ignis is a registered trademark of Whirlpool USA.
5019 512 10042
