AKG 781
AKR 633 - 635
D INSTALLATIONSANGABEN
Mindestabstand zur Kochfläche: 65 cm (Elektroplatten), 75 cm (Gas-, Öl- oder
Kohlekochplatten)
GB INSTALLATION SHEET
Minimum height above cooker: 43 cm (electric cookers), 65 cm (gas, gas oil or coal cookers)
F
NL
FICHE D'INSTALLATION
Distance minimale par rapport à la cuisinière: 43 cm (cuisinière électrique), 65 cm
(cuisinière à gaz, mazout ou charbon)
INSTALLATIESCHEMA
Min. afstand van het kooktoestel: 43 cm (elektrische kooktoestellen) 65 cm
(kooktoestellen op gas, olie of kolen)
E
P
FICHA DE INSTALACIÓN
Distancia mínima desde los quemadores: 43 cm (quemadores eléctricos), 65 cm
(quemadores a gas, gasóleo o carbón)
FICHA DE INSTALAÇÃO
Distância mínima do fogão: 43 cm (fogões eléctricos), 65 cm. (fogões a gás, óleo ou carbono)
I
*5
SCHEDA INSTALLAZIONE
Distanza minima dai fuochi: 43 cm (fuochi elettrici), 65 cm (fuochi a gas, gasolio o carbone)
ù ( ù ü+ ù $ ù þ
ü $ 12 .
) 12.1
.
) 2 " 012 0 " FP 0 2 !" 012 0 " FP 012 0 " .0
! #
02 !
0 .
# 0 ! # .
5019 100 75030
$.*
$.5
FFF
5
Ø
135mm
6 10x10mm
1
20mm
2
16mm
8
4
3
7
15
10
11
9
11 11
13
12
13
12
14
$.*
$.5
PRODUCT DESCRIPTION SHEET
1
4
2
3
1. Control panel.
2. Grease filters (inside extractor grille).
3. Lighting unit.
4. Pull-out steam deflector.
REMOVING AND RENEWING OR
CLEANING THE GREASE FILTER:
1. Unplug the appliance or switch off the mains power supply.
2. Pull out the steam deflector.
3. Remove the extractor grille.
4. Remove the grease filter fixing device.
5. Remove the dirty grease filter.
6. After renewing (for paper grease filters) or cleaning (for metal grease filters) the grease filter repeat the above steps in reverse to reassemble, making sure the entire extraction surface is covered.
MOUNTING OR RENEWING THE
CARBON FILTER:
1. Unplug the appliance or switch off the mains power supply.
2. Pull out the steam deflector.
3. Remove the extractor grille.
4. If a carbon filter is already mounted and needs renewing, press the release buttons
(b) and pull the filter out downwards.
5. If the filters are not mounted:
a. fit the carbon filter into the upper clips.
b. fasten using the lower clips.
6. Remount the extractor grille.
RENEWING BULBS:
1. Unplug the appliance or switch off the mains power supply.
2. Pull out the steam deflector.
3. Open the rear extractor grille.
4. Remove the burnt-out bulb and insert a new one. Use 40W max (E14) bulbs only.
5. Remount the extractor grille.
CONTROL PANEL
A. Light switch.
B. Speed selector.
O 1 2 3 4
B A
Õ
O I large amount of steam and fumes medium amount of steam and fumes small amount of steam and fumes
D GB F NL E P I GR
