STEADYSTEER™
INSTALLATION GUIDE
*988-12731-001*
Compliance statements
Europe
Navico declares under our sole responsibility that the product conforms with the requirements of:
• CE under LVD Directive 2014/35/EU
Navico Logistics Europe B.V. Laan van Europa 450,
3317 DB Dordrecht Netherlands
United States of America
¼
Warning: The user is cautioned that any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Declarations
The relevant Declaration of Conformity is available on the following websites:
• www.simrad-yachting.com
Trademark
®Reg. U.S. Pat. & Tm. Off, and ™ common law marks.
Visit www.navico.com/intellectual-property to review the global trademark rights for Navico Holding AS.”
Wiring and configuration
For wiring details refer to the documentation for your autopilot computer.
Before the SteadySteer™ can be used, make sure that the proper autopilot setting have been configured. Refer to the documentation for your autopilot computer.
System wiring example NAC™ -2
SteadySteer™ flow switch Red
Black
Yellow
Blue
Power input
+
-
System wiring example NAC™ -3
Ret
Black
Mode
Syssel
Red
SteadySteer™ flow switch
Power connector
Installation
A B
Min. 20 cm
(7.90”) C
Min. 60 cm
(23.63”)
A Mount horizontally
B Do not install the SteadySteer™ directly on the helm. Place a hydraulic hose between the helm and SteadySteer™.
C Mount with a distance of minimum 60 cm (2 ft) from disturbing magnetic influences, such as engines, ignition cables, or other large ferrous metals objects.
Single Helm
A
D
C
B
E
Dual helm
A
G
F
D
G
C
B
A SteadySteer™ (can be installed either on the starboard or port hydraulic line.)
B Starboard line
C Return line
D Port line
E Helm 1
F Steering cylinder
G Pump
H Helm 2
H E
F
Dimensional drawing
52.4 mm
(2.06”)
3 m
(10’)
1/4” NPT female
(both sides)
13.8 mm
(0.54”)
