Gamber-Johnson Zebra ZQ520 Printer Mount Installation Guide

INSTALLATION INSTRUCTIONS
Product
7160-1053
PRINTER MOUNT, ZEBRA ZQ520
Revision
Form
REV.A
INST-817
Printing Spec: PS-001
The Zebra ZQ520 printer bracket is designed to be mounted to various
Gamber-Johnson forklift mounts with an AMPS hole pattern.
• Attach the bracket to the printer by inserting the tabs into notches on the
printer and installing (2) M4 x 8mm screws, from hardware bag, into bottom
of the printer.
• Attach the bracket to Gamber-Johnson Motion Attachment using (4) #10
Flat Washers and (4) #10-32 Nylok Nuts supplied in hardware bag.
Bracket
Tabs
(2) M4 x 8mm
Screws
Motion Attachment with
AMPS hole pattern
(4) #10 Flat Washers
(4) #10-32 Nylok Nuts
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© Copyright 2018 Gamber-Johnson, LLC
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868