Extron TeamWork 400 Setup Guide
Extron SM Series
Extron SM Series cables are designed for use with Extron TeamWork systems and feature a Share button for remote input source selection and a control pigtail that can be wired directly into Extron switchers with contact closure and tally outputs. All versions of the Show Me cable are male to male.
Capabilities:
- Switch input sources remotely using the Share button
- Trigger the switcher to select the connected source device with a momentary contact closure
- Light up the Share button using the +5 VDC supply voltage provided by the source device
- Support embedded audio and CEC signals (digital Show Me cables only)
Advertentie
Advertentie
INPUT
To Source
Device Share Button
Three-Conductor
Pigtail for Contact
Closure and Tally
OUTPUT
To Switcher
Show Me™ Cable Series
The Extron Show Me cables are for use with Extron TeamWork ™ systems. They feature a
Share button for remote input source selection and a control pigtail, which can be wired directly into Extron switchers with contact closure and tally outputs. All versions of the
Show Me cable are male to male.
INPUT
To Source
Device Share Button
Three-Conductor
Pigtail for Contact
Closure and Tally
Installation
1. Connect the input end of the Show Me cable to the source device.
2. Connect the output end to the Extron switcher.
3. Connect the black (Tally Out) and red (Contact) pigtail wires as shown at right. The number under the Tally Out and Contact pins corresponds to that particular video input on the switcher.
NOTES:
• The drain wire does not need to be wired to the switcher. The Show Me cables are grounded via the video connectors.
•
REMOTE
Do not connect the Show Me cable pigtail wires to the +V pin on the Extron switcher.
1 2 3 4 +v
CONTACT RS-232 AUTO
REMOTE
OUTPUT
To Switcher
1 2 3 4
+v
CONTACT RS-232 AUTO
1 2 3 4 G
Yellow
Tx Rx
Green
Pigtail
REMOTE
TALLY OUT
1 2 3 4
CONTACT
+v
RS-232 AUTO
Red
1 2 3 4 G Tx Rx
Black
Pigtail
1 2 3 4 G
Yellow
Tx Rx
Green
Pigtail
Operation
Press the Share button to switch the connected source to the main presentation display.
Extro n
Pressing the Share button creates a momentary contact closure, which triggers the switcher to select the connected source device. If a tally output is available, the button lights up blue.
HDMI Show Me Cables
NOTES:
• The source device provides the +5 VDC supply voltage needed to illuminate the
Share button. This is standard for both analog (VGA) and digital source devices.
If the source device does not supply this +5 VDC, the Share button will not illuminate. Some mobile devices do not provide the required voltage to light up the button.
• Digital Show Me cables support embedded audio and CEC signals. The VGA
Show Me cable does not support audio.
Extron Headquarters
+1.800.633.9876 (Inside USA/Canada Only)
Extron Europe
+31.33.453.4040
Extron Asia
+65.6383.4400
Extro n
Extron China
+86.21.3760.1568)
HDMI Show Me Cables
+81.3.3511.7655
+971.4.299.1800
Extron Australia
+61.8.8113.6800
Extron India
+91.80.3055.3777
68-2321-50
Rev. E
04 17
© 2017 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com
Downloaden
Advertentie