PET GEAR Jogger No-Zip Pet Stroller Instruction manual

For The ON-THE-GO Pet™
INSTRUCTION MANUAL
JOGGER NO-ZIP PET STROLLER
PG8400NZ/PG8450NV
Interior Dimensions:
30"L x 13"W x 22"H
To see our full line of products, visit us online at: www.petgearinc.com
CUSTOMER SERVICE HELP DESK
[email protected]
Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday
PARTS LIST
Check that you have all the parts shown BEFORE assembling your product.
If any parts are missing, call Customer Service.
Axle
Front Wheel
2-Back Wheels
Removable
Waterproof Liner
Back Tray
Stroller
UNFOLDING THE STROLLER
Step 1. Release folding latch (A).
tep 2. Spread handle (B) and seat
S
apart until the frame clicks and locks
on both sides.
Step 3. Ensure that the stroller is
locked in on both sides before using.
2
JOGGER NO-ZIP PET STROLLER • PG8400NZ/8450NV
B.
A.
OPENING THE STROLLER
Spread the canopy apart to the open position.
Apply brake lever by pushing down with toe.
Ensure brakes are applied when parking stroller.
Release by lifting brake lever with toe.
WARNING: Never leave your stroller parked
without applying brakes.
Canopy
Back View of Stroller
Step Here
BACK WHEEL ASSEMBLY INSTRUCTIONS
Push back wheels until they easily click into place.
Shown with both back wheels in place.
JOGGER NO-ZIP PET STROLLER • PG8400NZ/8450NV
3
BACK WHEEL ASSEMBLY INSTRUCTIONS
To connect or release wheel from axle, squeeze pin in.
Pin
FRONT WHEEL ASSEMBLY INSTRUCTIONS
Step 1. To attach front wheel, slide plastic wheel
support up and into tubing.
Step 2. Slide wheel up, until velco pins pop out
of holes.
Velco Pin
Tubing
4
Tubing
JOGGER NO-ZIP PET STROLLER • PG8400NZ/8450NV
Velco Pin
FRONT WHEEL ASSEMBLY INSTRUCTIONS
Step 3. To use stroller in locked position for jogging,
push pin in.
Locked
Position
Step 4. To use stroller in swivel position, pull pin
down, and to the right.
Swivel
Position
TO SECURE COMPARTMENT TO FRAME
Step 1. Open stroller and pull
compartment down.
Step 2. Clip onto frame.
JOGGER NO-ZIP PET STROLLER • PG8400NZ/8450NV
5
TO SECURE LATCH
Step 1. To close compartment, pull
downward and clip the canopy into the
front of the stroller until it locks.
Step 2. To open the stroller canopy,
simply push and release button to
unlock.
TO SECURE SIDE FLAP
To help secure compartment, Velcro flap around
tube and fasten to the bottom of the compartment.
6
JOGGER NO-ZIP PET STROLLER • PG8400NZ/8450NV
FOLDING THE STROLLER
Step 1. NOTE: Before folding the stroller, unclip steel
latch, and open the canopy.
C.
Step 2. Slide second frame lock release (C) to the right,
while squeezing the main frame lock release (D) rotate
the folding mechanism almost 180 degrees forward
until stroller releases and handle is lowered.
SLIDE TO RIGHT
C.
D.
SLIDE TO RIGHT
AND ROTATE 180 DEGREES FORWARD WHILE
SQUEEZING MAIN FRAME (D) LOCK RELEASE
TO ASSEMBLE BACK TRAY
Step 1. To assemble the back tray, first align a
hole on one side of the tray with one of the bolts
on the handle of the same side of the stroller.
Step 2. Snap one side of the tray over the bolt
on the handle then repeat for the other side.
8
JOGGER NO-ZIP PET STROLLER • PG8400NZ/8450NV
LOOKING AFTER YOUR STROLLER
•
•
•
•
•
Always store product in a clean, dry place.
Not recommended for use on the beach.
Do not put heavy items on top of the stroller.
Clean frame by wiping with a lightly oiled cloth.
Do not use detergent or abrasives. Spot clean fabric with dry cleaning fluid or mild soap
and warm water.
• To ensure easy maneuverability and to minimize wear and tear, (especially wheels, axles,
and swivels), keep all moving parts clean and lubricated with WD40® or light machine oil.
• NOTE: Do not lubricate brake components or swivel locks.
• Regularly check stroller for loose parts. These should be tightened or replaced.
WHEEL MAINTENANCE
• T
o clean and lubricate front and rear wheels, push out locking lever under wheel housing
to release rear wheel.
• To ensure ease of maneuverability and to minimize wear and tear, keep all moving parts
clean and lubricated with WD40® or light machine oil.
• Push wheel sets back on until they click and lock in position; pull on wheel housings to
ensure they are secure.
• Push stroller back and forth and rotate swivels around to work in lubricant.
• Clean the rear wheel assembly and the rest of the frame with warm, soapy water; clean
off with warm water and dry thoroughly.
• NOTE: Do not lubricate brake components or swivel locks.
JOGGER NO-ZIP PET STROLLER • PG8400NZ/8450NV
9
WARNING!
FOR PETS ONLY.
Not intended to be used as a restraining device for aggressive or dangerous animals that dig, chew or paw
aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage caused by aggressive,
destructive, immature or untrained animals. Do not use near an open or exposed flame. Failure to follow these
warnings and the instructions could result in serious injury or death.
• D
o not carry additional bags, goods, or accessories in or on stroller except as recommended
in the manufacturer’s instructions.
• Recommended use of an approved safety restraint correctly fitted and adjusted.
• Do not leave pet unsupervised in stroller.
• Before making adjustments to stroller ensure that pet’s body is clear of any moving parts.
• This stroller is designed for one pet only.
• Do not hang bags from handles as this may cause the product to become unstable.
• Do not use on escalator or stairs; fold stroller and carry.
• Put on brake whenever you park the stroller.
• Ensure stroller is completely erected and check that all locks are engaged before placing pet
in stroller.
• Do not overload as stroller may become unstable; maximum weight of pet using this stroller
not to exceed 75 lbs.
• Any goods carried in the basket not to exceed 6 lbs.
REPLACEMENT PARTS
Use only PET GEAR replacement parts.
Please have your model number ready before calling.
You can also request parts: http://www.petgearinc.com/main.asp?sel=2
192 Sheldon Avenue • West Rutland, VT 05777 • 877-752-9123 • www.petgearinc.com
10
JOGGER NO-ZIP PET STROLLER • PG8400NZ/8450NV