A
B
C
Assembly Instructions
MUSE CHAIR
F
G
Item Part Name Part #
A
B
Seat Shell
RED/WHT
Frame
G00074RED/G00074WHT
G00075
C
Chair Legs
RED/WHT/WOOD
Qty
1
1
G00076RED/G00076WHT/G00076WOOD 1
D Bottom G00077RED/G00077WHT 1
E Screws G00078 1
Washers
Nut Plate
G00079
G00080 1
1
H
5mm
Hex Wrench G00081 1
Warning
1. Product is for single person use only.
2. Do not use this chair unless all bolts and knobs are securely tightened.
3. Check that all bolts and knobs are tightened every six months or as needed.
4. Dispose of packing material properly. Do not use plastic cover as a head covering. Suffocation may result.
5. Do not use this chair as a stepladder.
For assistance, call (888) 471-1616, or www.youtube.com/user/ideskInc1
1
Turn seat shell upside down.
Push nut plates into slots on the bottom of seat shell with a flat screwdriver. All nut plates are identical. slot
G
G
4
Install washers and screws through frame and bottom as shown into nut plates and tighten with hex wrench.
E
F
B
5
Fasten chair legs onto frame as shown.
C
D
2
With the arrows on bottom facing the front of the chair, place bottom on seat shell. Make sure the holes in the bottom are aligned with threaded holes in the nut plates.
3
Place frame above bottom.
Make sure the holes in frame and bottom are aligned with the threaded holes in the nut plates.
D B
D
A
6
A
Turn the chair to normal use position and make sure all 4 legs touch the ground. In case of uneven floor, rotate the chair legs to level the chair.
B
C
A
B
Assembly Instructions
MUSE CUSHION
Item Part Name Part #
A Muse Chair
B Cushion G00272GRY
Qty
1
1
Warning
1. Product is for single person use only.
2. Do not use this chair unless all bolts and knobs are securely tightened.
3. Check that all bolts and knobs are tightened every six months or as needed.
4. Dispose of packing material properly. Do not use plastic cover as a head covering.
Suffocation may result.
5. Do not use this chair as a stepladder.
For assistance, call (888) 471-1616, or www.youtube.com/user/ideskinc1
1
Clear the surface with cleaning solution.
Place the cushion (B) on the center of the seat shell (A) and make sure the position does not exceed the seat edge.
Align cushion with
PP curvature
B
2
Peel off the film of each adhesive foam tape under cushion (B). Make sure to align cushion (B) then press it firmly onto the seat surface.
Peel off !
Press!
A
