Vertical Slow Juicer

SJV-107

OPERATION MANUAL

Please read this manual carefully before using

2

TABLE OF CONTENTS

1. General Safety Regulations ...................................................................................3

2. Product Introduction .............................................................................................4

3. How to Assemble .................................................................................................5

4. Using the Slow Juicer ..........................................................................................6

5. How to Disassemble ...........................................................................................7

6. Cleaning and Maintenance ...................................................................................8

7. Before Using ........................................................................................................9

8.Troubleshooting .................................................................................................10

1. GENERAL SAFETY REGULATIONS

Special Notice:

To ensure the safe usage of this machine and to avoid injury and property damage to you and to others, please read this instruction manual carefully and follow all of the safety warnings and precautions. Failure to follow the safety warnings may lead to accidental injury or damage. Do not allow unattended children or persons with disabilities to use this machine.

Safety Warnings:

• This appliance is for household use only. It is not for commercial use.

• It is strictly prohibited to use this appliance during non-load operation or overloaded

operation.

• Do not touch moving parts during operation or injury may occur.

• Do not use this appliance on a tilted or unstable table or surface.

• Do not use finger, spoons, knives, chopsticks, or other foreign objects to push

produce into the Feeding Chute.

• Do not use damaged or malfunctioning electrical sockets or fire or personal injury

may occur.

• Do not use the appliance near high temperatures or fire or personal injury may occur.

• If the plug, power cord, or other parts are damaged, stop using the appliance

immediately. Contact the service center for repair or replacement before use.

• Before disassembling the appliance, make sure that the power is off and the

appliance is unplugged.

• Damage to the power cord must be repaired or replaced by the manufacturer or its

authorized service center.

• Keep out of the reach of children. Do not let children or disabled persons operate the

appliance unattended.

• Do not use accessories that did not come with this appliance.

• Before using the appliance, please confirm that the power is in accordance with the

specification of this appliance to avoid damage or other risks.

• Ensure that each of the parts are clean and undamaged before using the appliance.

• Clean immediately after use.

• If the appliance does not work, refer to the Troubleshooting section of this guide.

If the appliance still does not function normally, contact your service center for

maintenance or repair. Do not disassemble the appliance by yourself.

• This appliance is not designed to grind dry goods such as rice, dried soybeans,

or grains.

• Keep this appliance at least 12 in. / 30 cm away from other appliances.

3

4

2. PRODUCT INTRODUCTION

Components Name & Function

q r w u i o t e a y

No Name Function q Juicing Screen Separates the juice from the pulp.

w Auger Housing Where all the magic happens.

e Main Body The powerhouse of the juicer.

r Pusher Lets you get pushy with your produce when it does not want to go down.

t Feeding Chute Specially designed to help autofeed your produce into the juicer.

y Auger Designed to harness the power of the motor to crush through the toughest produce.

u Slicer i Brush

Lets you slice fruits and vegetables faster than a fruit ninja.

Multitasking tool that makes cleanup a breeze.

o Pulp Container Catches pulp.

a Juice Container Catches juice.

Specification:

Model NO Rated Voltage Rated Frequency Rated Power Continuous Working Time

SJV-107 110-120V or 220-240V 50/60Hz 200W up to 10 minutes/use

1. Attach the Auger

Housing

Align the “ • ” mark on the Auger Housing with the

“ ” mark on the Main

Body, then rotate clockwise so that the “ • ” mark is aligned with the “ ” mark.

3. HOW TO ASSEMBLE

4. Attach the Feeding

Chute

Align the “ • ” mark on the

Feeding Chute with the

“ ” mark on the Auger

Housing, then rotate clockwise so that the “ • ” mark is aligned with the “ ” mark.

2. Insert the Juicing

Screen

Insert the Juicing Screen into the center of the Auger

Housing until it is firmly seated.

5. Use the Included

Accessories

Place the Juice Container and Pulp container under their respective outlets on the Auger Housing. Insert the Pusher into the Feeding

Chute.

3. Insert the Auger

Insert the Auger into the center of the Juicing

Screen and through the silicone sealing ring of the Auger Housing.

Firm pressure may be needed.

5

6

4. USING THE SLOW JUICER

Please thoroughly clean all non-electrical parts with soap and water before using the juicer for the first time. Use a damp cloth or sponge to clean the Main Body. Do not submerge or use running water to clean the Main Body.

The juicer has a built-in safety switch that will prevent the juicer from operating unless all the parts are assembled correctly.

Power Switch:

ON: Press the top portion of the Power Switch to the ON position to start the motor.

Press the bottom portion of the Power Switch to turn off the motor.

REV: Press and hold the bottom portion of the Power Switch in the REV position to run the motor in reverse. This is helpful to clear out any hard produce that may cause the juicer to stop.

1. Remove Feeding Chute

Rotate the Feeding Chute counterclockwise until the

“ • ” mark is aligned with the “ ” mark.

Remove the Feeding Chute by pulling upwards.

5. HOW TO DISASSEMBLE

3. Remove the Juicing

Screen

Pull the Juicing Screen straight up and out of the

Auger Housing.

2. Remove Auger

Pull the Auger straight up and out of the Juicing

Screen and Auger Housing.

4. Remove the Auger

Housing

Rotate the Auger Housing

“ counterclockwise until the

• ” mark is aligned with the

“ ” mark on the Main

Body. Remove the Auger

Housing by pulling upwards.

7

8

6. CLEANING AND MAINTENANCE

1. Clean the following parts with soap and running water. These parts may be soaked for

easier cleaning. Use both ends of the Brush to thoroughly clean and remove any left

over pulp.

2. Use a damp cloth or sponge to clean the Main Body. Do not submerge or use running

water to clean the Main Body.

7. BEFORE USING

Precaution Reason

Do not use ice. Ice can get harder when it is squeezed and

damage

Do not use hard or dried food. Certain hard or dried foods can damage the parts.

Cut fibrous produce into

1-inch pieces.

Long and stringy fibers can wrap around the

Auger and cause the juicer to stall or damage

Do not put hard pits or seeds into the juicer.

Hard pits and seeds can damage the juicing parts. Please remove pits and seeds from the

produce

Only use the included Pusher to push food into the Juicer.

Other objects such as knives or spoons can damage the juicing parts.

Do not operate the juicer for more than 10 minutes at a time.

Overusing the juicer can cause the motor to overheat. Please wait 5-10 minutes between

operations.

Do not put the pulp through a second time.

Squeaking sounds are normal.

Re-juicing the pulp can cause the juicer to back up and damage the juicing parts.

Enjoy your juice as soon as possible. We recommend drinking your juice immediately for the best taste and nutrition.

It from friction as the pulp rubs against the moving parts of the juicer.

Feed the juicer slowly. Please keep the juice level in the Auger

Housing under the MAX line or the juice may

overflow.

9

10

8. TROUBLESHOOTING

The motor does not turn on.

• Check that the power cord is plugged into a working socket.

• Check that all parts have been assembled correctly.

• Contact your customer service center.

Trouble removing the Feeding

Chute.

• Check whether there is a lot of pulp in the Auger Housing.

If so, turn the juicer on to remove the excess pulp.

• Check whether there is any hard objects stuck in the Feeding

Chute. The REV button may help dislodge it.

• Contact your customer service center.

The juicer stops during operation.

• Use the REV button to dislodge any stuck pulp or produce.

• Feed the juicer at a slower pace.

• Cut your produce into smaller pieces.

• Contact your customer service center.

Leak from the bottom of the

Auger Housing.

• Check to see if the silicone sealing ring is in place at the

bottom center of the Auger Housing.

• Check to see if there is any damage to the silicone sealing ring.

• Feed the juicer at a slower pace.

• Contact your customer service center.

The Auger

Housing moves while juicing.

• This is normal during operation and is designed to reduce strain

on the moving parts.

11

Tribest Corporation

1143 N. Patt St., Anaheim, CA 92801 toll free: 888-254-7336 | tel: 714-879-7150 www.tribest.com | [email protected]

©2018 Tribest Corporation V06052018