ACC ADAPTER
INSTRUCTIONS
AD-118
Thank you for purchasing the AD-118 acc adapter
.
Please read these instructions thoroughly before using the AD-118.
SUPPLIED ACCESSORY
Ferrite core
( See the back page for details.)
PRECAUTIONS
CAUTION: NEVER expose the adapter and the connected transceiver to rain, snow or any liquids.
NEVER disassemble the adapter. The adapter contains no user-serviceable parts.
DO NOT use harsh solvents such as benzine or alcohol to clean the adapter, because they can damage the adapter’s surfaces.
BE SURE to attach the socket cover when the accessory is not connected.
Use only the recommended accessories*.
Connection to other equipment may cause problems, such as;
• Audio does not output correctly.
• The transceiver does not detect the connected accessory.
• The PTT switch of the connected accessory is disabled.
* See the back page for details of the recommended accessories.
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, United Kingdom, Germany,
France, Spain, Russia and/or other countries.
DESCRIPTION
Socket cover q w e q ACCESSORY SOCKET
Connects to the recommended accessories.
See the back page for details of the recommended accessories, pin assignments and connections.
w PTT SWITCH
Hold down to transmit; release to receive.
• While holding down this switch, speak into the microphone of the accessory at a normal voice level.
e CONTACT PINS
Contacts with the transceiver’s multi connector.
See the back page for details of the pin assignments and connections.
PIN ASSIGNMENTS AND CONNECTIONS
AD-118
Accessory socket Contact pins
Transceiver
Multi connector t y q r e w
(Top panel view)
AD-118 q w e r t y
5.1 V e y w r q
Front i y w o u t q
(Side panel view)
1 ½ F
2.2 k ø
(Side panel view)
Transceiver w i o y q u
External Mic. input
External Mic. power
External Speaker (+)
Ground
External PTT input
ACC detection
FERRITE CORE ATTACHMENT
The ferrite core that comes with the AD-118 must be attached to the headset side cable of the V4-BA2MD1, as close to the PTT switch as possible.
It is not necessary to attach the ferrite core to the V4-10148 and V4-10001.
PTT Switch Ferrite core
Make sure to twist the cable around the ferrite core.
To the AD-118 To the Headset
RECOMMENDED ACCESSORIES
• V4-10148 : Noise cancelling over-the-head headset
• V4-10001 : Noise cancelling behind-the-head headset
• V4-BA2MD1 : Light weight behind-the-head headset
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan.
A-6827X-1EX Printed in Taiwan
© 2010 Icom Inc.