Programming Quick Guide
-LS6300J
Installation
Make sure that the scanner has the correct cable to plug into PC as below
described,
After you plug cable into PC and hear the beep sound, the scanner can read
the barcodes now.
Keyboard Country (FOR USB HID Only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ‘ \ < > ~
USA
(Original setting)
RS232/ USB serial
B1
ENABLE
CODE 93
DISABLE
ENABLE
CODE 128
DISABLE
ENABLE
GS1-128
DISABLE
ENABLE
UPC-A
DISABLE
ENABLE
UPC-E
DISABLE
ENABLE
EAN 8
DISABLE
1D Symbologies – 1
ENABLE
ENABLE
CODABAR
CODE 39
DISABLE
DISABLE
B2
*Note : Please install PL-2303 driver for USB serial
DISABLE
Portuguese (Portugal)
Reset Configuration to Default :
USB HID
Matrix 25
Spanish
Portuguese (Brazil)
A1
ENABLE
France
Italy
If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan A1 for USB HID or B1~B2 for RS232 or
USB Serial. This will reset the scanner to its factory defaults.
1D Symbologies – 2
ENABLE
Interleaved 25
DISABLE
ENABLE
Industrial 25
DISABLE
1
ENABLE
ENABLE
EAN 13
ISBN
DISABLE
DISABLE
1D Symbologies – 3
ENABLE
ENABLE
ISSN
GS1 DataBar
DISABLE
2D Symbologies
PDF 417
ENABLE
DISABLE
DISABLE
QR Code
ENABLE
ENABLE
ENABLE
GS1 Databar
Limited
GS1 Databar
Expanded
DISABLE
DISABLE
Micro QR Code
DISABLE
ENABLE
DISABLE
Data Matrix
ENABLE
DISABLE
Aztec Code
ENABLE
DISABLE
Information in this document is subject to change without notice.
For more information, please visit:
www.riotec.com.tw
R_181023_01
2
">
