GB.TBLZ58.160519
Installation Instructions, Internal temp. sensor, TBLZ-1-58
GOLD
1. General
The sensor is used for the exhaust air regulation function or as a temperature monitor/alarm sensor for the
GOLD RX (rot. heat exchanger). The sensor is supplied with a cable. The length of the cable must be specified when placing an order: 1 — 10 metres
2. Range of Application
The temperature sensor is intended for use in extra functions that require several sensors at other locations than that of the AHU’s standard sensor.
3. Installation
Install the sensor according to the figure in the external duct system.
GOLD, supply air fan, left, upper level
Mount the sensor here by the temperature monitor function. Connect to the contact marked "SENSOR 3".
Supply air
+
+
Install the sensor here by the exhaust air regulation function. Connect to the contact marked "SENSOR 4".
Exhaust air
GOLD, supply air fan, right, lower level
4. Technical Data
Enclosure class
Range of measurement
IP 34
-55 °C – +125 °C
5. Electrical Connections
Connect the modular connector of the sensor to the control units contacts marked "SENSOR 3" or "SENSOR
4", depending on the required function and direction of airflow, see figure.
The electrical connections should be wired in accordance with local electrical safety regulations.
The temperature sensor is digital and depending on the nature of the installation may be sensitive to external interference. The cable to the temperature sensor must not be run parallel with and near a power cable. If the sensor cable crosses a power cable, it should cross it at a
90° angle.
Install the sensor here by the exhaust air regulation function. Connect to the contact marked "SENSOR 3".
Install the sensor here by the temperature monitor function. Connect to the contact marked "SENSOR 4".
+
Exhaust air
+ Supply air
Digital temperature sensors require correct polarity. Be careful when you wire the conductors.
Registered design. The company reserves the right to make design changes without prior notice.
www.swegon.com 1
