AEK1700

Aztech Electric Kettle

USER MANUAL

PlEAsE rEtAin this UsEr MAnUAl for fUtUrE UsE.

•

•

•

•

•

•

•

•

•

•

•

•

•

•

sAfEtY instrUCtions

this product has been designed for domestic use only.

the manufacturer will not take any responsibility if a misuse or a failure of complying with the instructions provided in this user manual was the issue.

Before you connect the kettle to the power supply, make sure that the voltage indicated on the rating plate located at the bottom of the kettle matches the mains voltage in your home. if it does not match, contact your dealer and do not use the kettle.

Ensure that the appliance is placed on a firm and flat surface. Do not put it on the edge of a table or bench.

Always hold your appliance by its handle, since the outer surface may be hot.

Do not open the lid while the kettle is in use.

Do not lift the lid while boiling water in the kettle.

Do not fill the kettle above the MAX level (1.7L). Boiling water may splash out of the kettle if overfilled.

Never immerse the kettle or its cord in any kind of liquid. Do not allow liquid to penetrate the electrical parts of this kettle.

if the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

Do not repair the device yourself, but rather consult an authorized expert.

Your kettle must only be used with its attached lid and the power base supplied with it.

The Electric Kettle has a Boil-Dry feature which automatically turns off the appliance if you accidentally switch it on without any water. if this occurs, allow the Electric kettle to cool down first before filling it with cold water.

Cleaning and user maintenance SHOULD NOT BE MADE by children unless they are OLDER THAN 8 and SUPERVISED. Keep the appliance and its cord safe and out of reach from children aged less than 8 years old.

1

PACKAGE ContEnts

1) Aztech AEK1700

2) 360 o Gyral Base

3) User Manual

4) Easy Start guide

5) Warranty Policy

ElECtriC KEttlE fEAtUrEs

2

3

6

4

4.

5.

6.

1.

2.

3.

spout and filter lid release Button

Water Window and label handle

360 o Gyral Base on/off switch with

Power indicator light

5

BEforE UsE

Before first use, fill the kettle with cold water to the MAX water level mark, bring to boil and discard boiled water tWiCE. this will ensure that residues left from the manufacturing process are completely removed before using it for drinking.

foUr stEPs in BoilinG WAtEr

STEP 1: Position Your Electric Kettle

a.

b.

Position the power base on a smooth, flat and dry surface.

the underside of the power base is fitted with a cable storage feature.

Unwind the length of the cord required to reach the power outlet.

STEP 2: Position Your Electric Kettle

a.

b.

c.

lift the kettle from the power base and press the lid release button to open the lid.

fill the kettle with cold water between the MIN and MAX markings on the water level indicator through its opening or its spout.

Close the kettle’s lid and place the kettle back to its power base. Make sure the lid is securely closed.

STEP 3: switch in on

to start boiling, press the on/off switch down to “I”(on) position. The power indicator will light up and the kettle will start to boil.

STEP 4: it will AUtoMAtiCAllY

tUrn off

the Electric Kettle automatically turns off after boiling. You may also stop it from boiling by lifting the ON/OFF switch to “0”

(off) or by lifting the kettle away from its power base.

KETTLE CARE AND CLEANING

Cleaning the Filter

a.

b.

c.

With the kettle’s lid open, gently pull the filter out of its retaining slot and lift the filter out of the kettle.

Rinse the filter with warm water and gently remove any attached scales using a soft brush.

After rinsing, gently slide it down into its slot until it clicks into place.