L24DVDB21_QSG_110218_flo.pdf 1 18/02/2011 5:50 PM

Connecting the Aerial Connecting to the Mains Socket

24” HD Ready 1080p Digital LCD TV with DVD Player

Quick Start Guide

L24DVDB21

Thank you

for purchasing your new Logik TV.

Your new TV incorporates the latest technology to enhance your viewing experience. We would suggest that you allow about 20 mins for initial setup.

Please follow this guide for a successful first time installation.

GB

1

Unpacking

Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to any local regulations.

LCD TV

Base Stand

Remote Control /

AAA Batteries x 2

Screw A

Instruction Manual

Quick Start Guide

Digital Switchover

Addendum

Operating Your Remote Control

1. Press and lift the back cover up to open the battery compartment of the remote control.

2. Insert two AAA size batteries. Close the battery compartment cover.

Install the batteries correctly by following the polarity

(+ and -) indications in the battery compartment.

Installing the Base Stand

screw

Screw A x 1

(P.N.: 209100412B1)

1. Lay the TV down on a flat surface with the back side facing up.

Please make sure to place a soft cushioned material (such as a pillow or thick piece of foam) beneath the screen.

2. Align the screw hole and then secure the base stand with the provided 1 screw.

AC-INPUT

100-240V~ 50/60Hz HDMI INPUT

VIDEO

PC

AUDIO INPUT

SCART

OR

VGA INPUT

RF INPUT

RF coaxial cable

(not included)

Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the RF IN (75 Ω ) socket on the right rear side of your TV.

Do not connect the TV to the mains supply until you have completed all the connections.

To mains socket

1. Connect the mains cable to the mains socket after you have completed all the connections.

2. At this stage, the TV switches to standby mode. The red LED indicator will illuminate on the front panel of the TV.

3. In standby mode, press the button on the side panel of the

TV or on the remote control to turn the TV on. The red LED indicator will turn green.

Turning the TV On for the First Time

The first time you turn the TV on, it will go straight into First Time Installation .

First Time Installation

Please ensure aerial is plugged in!

Then press OK button.

1. Press the OK button to start First Time Installation.

OSD Language

Cesky

Dansk

English

Deutsch E k

Fran ais

Hrvatski Nederlands Portugues

Italiano

Magyar

Norsk

Polski

Pycck

OK

2. Press the OK button to confirm English as your desired language to be displayed on the menu.

Country

UK

Australia

Austria

Belgium

Bulgaria

Croatia

Czech

Denmark

Finland

France

Germany

Greece

Hungary

Italy

Luxembourg

OK

3. Press the OK button to confirm UK as the country where you will operate the

TV.

Channel Tuning

TV : 3 Channel(s)

DTV : 0 Channel(s)

Radio : 0 Channel(s)

Date : 0 Channel(s)

36%... 668.75MHz (TV)

Please press MENU to skip.

4. Channel tuning will commence. This operation may take up to

6 minutes. The display will show the progress of the tuning and the number of channels found.

Well done,

your new TV is now ready to use. You will find that there are many exciting features available. To get to know all these features, please take some time to read the instruction manual provided with your TV.

If after reading the instruction manual you have additional questions related to the use of your TV please call our Customer Technical Services

Centre. Tel: 0844 800 6020 (UK only - Operating hours 9:00am to 6:00pm)

(P.N.: 4033C241302)