Book Rack for an X-Stack ® Chair
If you have a problem, question, or request, call your local dealer, or Coalesse at 1.800.627.6770
Or visit our website: www.coalesse.com
© 2010 Coalesse
San Francisco, California U.S.A.
Printed in U.S.A.
#25 STAR HEAD
Page 1 of 3
939504449 Rev A
1.
Position chair as shown on protective surface.
2.
Use #25 star point bit and driver to remove two (2) star point screws and rubber bumpers from underside of chair.
3.
Align and guide front legs of book rack under front leg brace. Tilt book rack and push towards rear of seat against chair seat extrusion, (approx. 1 inch).
2
1
3
FRONT LEG
BRACE
BOOK
RACK
Page 2 of 3
939504449 Rev 8
4.
Squeeze rear book rack rods inward slightly and rotate to set against bottom surface of chair. Release rods when positioned under rear leg assembly.
Rods will widen to normal width and be temporarily retained under rear legs.
5.
Slide lower flange of left and right retainer brackets
(notch side up) under leg assemblies. Press bracket outward for notch to engage lower book rack rod. Align top hole of bracket with hole in rear leg assemblies and secure with
#25 star head screws removed from step 2.
REAR BOOK
RACK ROD
NOTCH
5
4
NOTE:
Front rod ends are installed under front legs and leg brace.
Page 3 of 3
939504449 Rev A
