139. 5375
Mo dela
O 315 MHz Security+* 3-Function
RAFTSMAN Remote Cana
Owner’ Manual
Only for use with 315 MHz Security*® garage door openers
and universal receivers that have an orange “learn” button.
To prevent possible SERIOUS INJURY or DEATH from a moving gate
Instructions are Described and Illustrated Below Or garage door:
e ALWAYS keep remote controls out of reach of children. NEVER
permit children to operate, or play with remote control transmitters.
e Activate gate or door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
+ ALWAYS keep gate or garage door in sight until completely closed.
NEVER permit anyone to cross path of moving gate or door.
The Remote Control Batteries
To prevent possible SERIOUS INJURY or DEATH:
e NEVER allow small children near batteries.
« lf battery is swallowed, immediately notify doctor.
1. Press and release the “Learn”
button. The learn indicator light will
glow steadily for 30 seconds.
The lithium batteries should produce
power for up to 5 years. To replace,
sat th vi : Open this end
2. Within 30 seconds, press and hold the pry open case with visor clip or frst to avoid
button on the hand-held remote. screwdriver, as shown. Insert cracking
batteries matching polarity housing
instructions inside the remote cover
. 3. Release the button when the light blinks. It K |, or on the printed circuit board.
has learned the code. — — .
) o Dispose of old batteries properly.
To Erase All Codes From Motor Unit Memory NOTICE: To comply with FCC and or Industry Canada (iC) rules, adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code setting or replacing the
, , | battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
To deactivate any unwanted remote, first erase all codes: Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
tt ” : following two conditions: (1) this device may not cause harmtui interference, and (2) this device must
Press and hold the learn” button until O [ON accept any interference received, including interference that may cause undesired operation.
the learn indicator light goes out
(approximately 6 seconds). All
previous codes are now erased.
Reprogram each remote or keyless
entry you wish to use.
To order replacement parts call...
~ 1-800-4-MY-HOME? (1-800-469-4663)
To Control the Opener Lights
NOTE: Not available with universal receiver.
With 315 MHz Security*® transmitters, a remote push button can
be programmed to operate the opener lights without opening
the door.
1. With the door closed, press and hold the remote button that
you want to contro! the light.
2. Press and hold the Light button on the door control.
3. Press and hold the Lock button on the door control.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button. The opener lights
should turn on or off but the door should not move.
© 2004, Sears, Roebuck and Co./ ® Registered Trademark / ™ Trademark / Service Mark of Sears, Roebuck and Co.
114A3018 ® Marca Registrada / ™Marca de Fabrica / * Marca de Servicio de Sears, Roebuck and Co. Printed in Mexico
">
